
ASTM A 334/A334M : 2004 : REV A : R2016
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by

Standard Specification for Seamless and Welded Carbon and Alloy-Steel Tubes for Low-Temperature Service
Hardcopy , PDF
21-10-2021
English
10-03-2016
This specification2 covers several grades of minimum-wall-thickness, seamless and welded, carbon and alloy-steel tubes intended for use at low temperatures.
Committee |
A 01
|
DevelopmentNote |
Supersedes ASTM A 334. (05/2002)
|
DocumentType |
Standard
|
Pages |
6
|
ProductNote |
Reconfirmed 2016
|
PublisherName |
American Society for Testing and Materials
|
Status |
Superseded
|
SupersededBy | |
Supersedes |
1.1This specification2 covers several grades of minimum-wall-thickness, seamless and welded, carbon and alloy-steel tubes intended for use at low temperatures. Some product sizes may not be available under this specification because heavier wall thicknesses have an adverse affect on low-temperature impact properties.
1.2Supplementary Requirement S1 of an optional nature is provided. This shall apply only when specified by the purchaser.
Note 1:For tubing smaller than 1/2 in. [12.7 mm] in outside diameter, the elongation values given for strip specimens in Table 1 shall apply. Mechanical property requirements do not apply to tubing smaller than 1/8 in. [3.2 mm] in outside diameter and with a wall thickness under 0.015 in. [0.4 mm].
1.3The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification. The inch-pound units shall apply unless the “M” designation of this specification is specified in the order.
1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
ASTM F 2015 : 2000 : R2019 | Standard Specification for Lap Joint Flange Pipe End Applications |
ASTM A 498/A498M : 2017 | Standard Specification for Seamless and Welded Carbon Steel Heat-Exchanger Tubes with Integral Fins |
ASTM F 2014 : 2000 : R2019 | Standard Specification for Non-Reinforced Extruded Tee Connections for Piping Applications |
ASTM A 1016/A1016M : 2018 : REV A | Standard Specification for General Requirements for Ferritic Alloy Steel, Austenitic Alloy Steel, and Stainless Steel Tubes |
ICC IMC International Mechanical Code : 2021 | International Mechanical Code |
ASTM A 1016/A1016M : 2002 | Standard Specification for General Requirements for Ferritic Alloy Steel, Austenitic Alloy Steel, and Stainless Steel Tubes |
ASTM E 23 : 2002 | Standard Test Methods for Notched Bar Impact Testing of Metallic Materials |
ASTM A 370 : 2011 | Standard Test Methods and Definitions for Mechanical Testing of Steel Products |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.