ASTM A 414/A414M : 2007
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Specification for Steel, Sheet, Carbon, for Pressure Vessels
Hardcopy , PDF
11-11-2014
English
15-05-2007
Important note : Users cannot be edited or removed once added to your Multi user PDF.| Committee |
A 01
|
| DocumentType |
Standard
|
| Pages |
4
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1 This specification covers hot-rolled carbon steel sheet for pressure vessels involving fusion welding or brazing. Welding and brazing technique is of fundamental importance and shall be in accordance with commercial practices.
1.2 The following grades are included in this specification:
| Mechanical Requirements | ||||
| Grade | Yield Strength, min | Tensile Strength, min | ||
| ksi | MPa | ksi | MPa | |
| A | 25 | 170 | 45 | 310 |
| B | 30 | 205 | 50 | 345 |
| C | 33 | 230 | 55 | 380 |
| D | 35 | 240 | 60 | 415 |
| E | 38 | 260 | 65 | 450 |
| F | 42 | 290 | 70 | 485 |
| G | 45 | 310 | 75 | 515 |
1.3 Hot-rolled carbon steel sheet is generally furnished in cut lengths and to decimal thickness only. Coils may be furnished, provided tension test specimens are taken to represent the middle of the slab as required by 5.1.4. The purchaser should recognize this may require cutting the coils to obtain test samples and results in half-size coils. The sheet is furnished to the following size limits:
| Width, in. [mm] | ||
| Thickness, in. [mm] | Over 12 [Over 300] | |
| 0.270 to 0.230 [7.0 to 6.0] | sheet (coils only) | |
| Under 0.230 to 0.057 [6.0 to 1.5] | sheet |
1.4 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.
1.5 Tolerances are found in General Requirements Specifications A 568/A 568M and A 635/A 635M. The appropriate General Requirements specification is applied based on the thickness and width of the product ordered.
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.