ASTM A 711/A711M : 2017 : REDLINE
Current
The latest, up-to-date edition.
Standard Specification for Steel Forging Stock
English
01-11-2017
Important note : Users cannot be edited or removed once added to your Multi user PDF.CONTAINED IN VOL. 01.05, 2017 Defines cast carbon and alloy steel ingots and strand castings, semi-wrought ingots and strand castings and rolled or forged blooms, billets, and slabs for forging.
| Committee |
A 01
|
| DevelopmentNote |
Supersedes ASTM A 711. (04/2007)
|
| DocumentType |
Redline
|
| Pages |
8
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Current
|
| Supersedes |
1.1This specification covers cast carbon and alloy steel ingots and strand castings, semi-wrought ingots and strand castings and rolled or forged blooms, billets, and slabs for forging.
1.2Blooms, billets, and slabs are semi-finished steel products, hot rolled or forged to approximate cross-sectional dimensions. Blooms and billets may be square, round, octagonal, or rectangular in section; slabs are rectangular. Although no invariable rule prevails between the terms blooms and billets, and they are frequently used interchangeably, the following size distinctions are in general use.
1.2.1Blooms—Cross-sectional area greater than 36 in.2 [230 cm2].
1.2.2Billets—Maximum cross-sectional area 36 in.2 [230 cm2].
1.2.3Slabs—Minimum thickness, 11/2in. [4 cm]; width, more than twice the thickness; and generally a cross-sectional area of not less than 16 in.2 [100 cm2].
1.2.4Ingots either top or bottom poured or secondary remelted are covered.
1.2.5Strand castings with or without additional reduction are covered.
1.3Supplementary Requirements (S1 to S19) of an optional nature are provided. They shall apply only when specified by the purchaser.
1.4The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.5Unless the order specifies the “M” specification, the material shall be furnished to the inch-pound units.
1.6This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
| ASTM A 29/A29M : 2016 : REDLINE | Standard Specification for General Requirements for Steel Bars, Carbon and Alloy, Hot-Wrought |
| ASTM E 381 : 2017 : REDLINE | Standard Method of Macroetch Testing Steel Bars, Billets, Blooms, and Forgings |
| ASTM A 275/A275M : 2015-05 | PRACTICE FOR MAGNETIC PARTICLE EXAMINATION OF STEEL FORGINGS |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.