ASTM A 775/A775M : 2007 : REV B : R2014

1.1This specification covers deformed and plain steel reinforcing bars with protective epoxy coating applied by the electrostatic spray method.

1.2Other organic coatings may be used provided they meet the requirements of this specification.

1.3Requirements for coatings are contained in Annex A1.

1.4Requirements for patching material are contained in Annex A2.

1.5Guidelines for construction practices at the job-site are presented in Appendix X1.

1.6This specification is applicable for orders in either SI units (as Specification A775M) or inch-pound units [as Specification A775].

1.7The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.8This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.