ASTM A 805/A805M : 2009 : R2016
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Specification for Steel, Flat Wire, Carbon, Cold-Rolled
Hardcopy , PDF
21-10-2021
English
11-05-2016
Important note : Users cannot be edited or removed once added to your Multi user PDF.CONTAINED IN VOL. 01.03, 2017 Describes carbon steel flat wire in coils or cut lengths.
| Committee |
A 01
|
| DevelopmentNote |
Supersedes ASTM A 805. (06/2009)
|
| DocumentType |
Standard
|
| Pages |
12
|
| ProductNote |
Reconfirmed 2016
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1This specification covers carbon steel flat wire in coils or cut lengths. Flat wire is classified as a cold-rolled section, rectangular in shape, 0.500 in. [12.7 mm] or less in width and under 0.250 in. [6.35 mm] in thickness.
1.2Low-carbon steel flat wire is produced from steel compositions with a maximum carbon content of 0.25 % by cast or heat analysis.
1.3Carbon spring steel flat wire is produced to a carbon range in which the specified or required maximum is over 0.25 % by cast or heat analysis.
1.3.1Two types of carbon spring steel flat wire are produced:
1.3.1.1Untempered cold-rolled carbon spring steel flat wire, produced to several desirable combinations of properties and
1.3.1.2Hardened and tempered carbon spring steel wire.
1.4Definite application flat wire is a product developed for a specific application and may be specified only by size and descriptive name.
1.5The values stated in either inch-pound units or SI units are to be regarded as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in non-conformance with this specification.
| MIL-STD-129 Revision R:2014 | Military Marking for Shipment and Storage |
| ASTM E 45 : 1997 : EDT 2 | Standard Test Methods for Determining the Inclusion Content of Steel |
| FED-STD-123 Revision H:2007 | MARKING FOR SHIPMENT (CIVIL AGENCIES) |
| SAE J419_198312 | METHODS OF MEASURING DECARBURIZATION |
| ASTM A 370 : 2011 | Standard Test Methods and Definitions for Mechanical Testing of Steel Products |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.