ASTM A 960/A960M : 2014 : REV A
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Specification for Common Requirements for Wrought Steel Piping Fittings
Hardcopy , PDF
26-11-2014
English
01-11-2014
Important note : Users cannot be edited or removed once added to your Multi user PDF.| Committee |
A 01
|
| DocumentType |
Standard
|
| Pages |
10
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy |
1.1This specification covers a group of common requirements that shall apply to wrought steel piping fittings covered in any of the following individual product specifications or any other ASTM specification that invokes this specification or portions thereof:
| Title of Specification | ASTM |
| Specification for Piping Fittings of Wrought | A234/A234M |
| Specification for Wrought Austenitic Stainless | A403/A403M |
| Specification for Piping Fittings of Wrought Carbon | A420/A420M |
| Specification for Butt-Welding, Wrought-Carbon | A758/A758M |
| Specification for As-Welded Wrought Austenitic | A774/A774M |
| Specification for Wrought Ferritic, Ferritic/Austenitic, | A815/A815M |
| Specification for Heat-Treated Carbon Steel | A858/A858M |
| Specification for Wrought High-Strength | A860/A860M |
1.2In case of conflict between a requirement of the individual product specification and a requirement of this general requirement specification, the requirements of the individual product specification shall prevail over those of this specification.
1.3By mutual agreement between the purchaser and the supplier, additional requirements may be specified (See 4.1.8). The acceptance of any such additional requirements shall be dependent on negotiations with the supplier and must be included in the order as agreed upon by the purchaser and supplier.
1.4The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text and the tables, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the specification. The inch-pound units shall apply unless the “M” designation [SI] of the product specification is specified in the order.
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.