ASTM A 961/A961M : 2012 : REV A
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Specification for Common Requirements for Steel Flanges, Forged Fittings, Valves, and Parts for Piping Applications
Hardcopy , PDF
11-11-2014
English
01-11-2012
Important note : Users cannot be edited or removed once added to your Multi user PDF.| Committee |
A 01
|
| DocumentType |
Standard
|
| Pages |
9
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1This specification covers a group of common requirements that shall apply to steel flanges, forged fittings, valves, and parts for piping applications under any of the following individual product specifications:
| Title of Specification | ASTM Designation |
| Forgings, Carbon Steel, for Piping Components | |
| Forgings, Carbon Steel, for General-Purpose Piping | |
| Forged or Rolled Alloy-Steel Pipe Flanges, Forged | |
| Fittings, and Valves and Parts for High Temperature | |
| Forgings, Carbon and Low Alloy Steel, Requiring Notch | |
| Toughness Testing for Piping Components | |
| Forged or Rolled 8 and 9 % Nickel Alloy | |
| Steel Flanges, Fittings, Valves, and Parts | |
| for Low-Temperature Service | |
| Forgings, Carbon and Alloy Steel, for Pipe Flanges, | |
| Fittings, Valves, and Parts for High-Pressure | |
| Flanges, Forged, Carbon and Alloy Steel for Low | |
| Temperature Service | |
| Forgings, Carbon Steel, for Piping Components with | |
| Inherent Notch Toughness | |
| Forgings, Titanium-Stabilized Carbon Steel, for | |
| Glass-Lined Piping and Pressure Vessel Service |
1.2In case of conflict between a requirement of the individual product specification and a requirement of this general requirement specification, the requirements of the individual product specification shall prevail over those of this specification.
1.3By mutual agreement between the purchaser and the supplier, additional requirements may be specified (see Section 4.1.2). The acceptance of any such additional requirements shall be dependent on negotiations with the supplier and must be included in the order as agreed upon between the purchaser and supplier.
1.4The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text and the tables, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. The inch-pound units shall apply, unless the “M” designation (SI) of the product specification is specified in the order.
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.