• Shopping Cart
    There are no items in your cart

ASTM B 103/B103M : 2015

Superseded

Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View Superseded by

Standard Specification for Phosphor Bronze Plate, Sheet, Strip, and Rolled Bar

Available format(s)

Hardcopy , PDF

Superseded date

14-10-2023

Superseded by

ASTM B 103/B103M : 2019

Language(s)

English

Published date

15-05-2015

€67.30
Excluding VAT

Committee
B 05
DocumentType
Standard
Pages
7
PublisherName
American Society for Testing and Materials
Status
Superseded
SupersededBy
Supersedes

1.1This specification establishes the requirements for copper-tin alloy (phosphor bronze), copper-tin-lead alloy (leaded phosphor bronze), and copper-tin-lead-zinc alloy (bearing bronze), plate, sheet, strip, and rolled bar. The phosphor bronzes commonly are used for deep drawing into bellows and stamping and forming into spring devices and into terminals and connectors for electrical apparatus because they combine high strength with high elongation. The leaded phosphor bronzes are used where strength, corrosion resistance, and machinability are required. The bearing bronze is used in bushings, bearings, and load-bearing thrust washers. The following alloys are covered:

Copper Alloy UNS No.2

Nominal Composition, %

Previously Used Designation

Copper

Tin

Zinc

Lead

C51000

95

5

. . .

. . .

A1

C51100

96

4

. . .

. . .

A 

C51180

96

4

. . .

. . .

. . .

C51900

94

6

. . .

. . .

 C52100A

92

8

. . .

. . .

C 

C52180

92

8

. . .

. . .

. . .

C52400

90

10 

. . .

. . .

D 

C53400

94

5

. . .

1

B1

C54400

88

4

3

4

B2

(A)SAE Specification CA 521 conforms to the requirements of UNS No. C52100.

Note 1:All of the above alloys contain small amounts of phosphorus, used as a deoxidant in melting, and to enhance the mechanical properties.

1.2The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3The following safety hazard caveat pertains only to the test method(s) described in this specification.

1.3.1This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.