• Shopping Cart
    There are no items in your cart

ASTM B 108/B108M : 2018 : EDT 1

Superseded

Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View Superseded by

Standard Specification for Aluminum-Alloy Permanent Mold Castings

Available format(s)

Hardcopy , PDF

Superseded date

03-10-2019

Superseded by

ASTM B 108/B108M : 2019

Language(s)

English

Published date

15-05-2018

€96.91
Excluding VAT

This specification2 covers aluminum-alloy permanent mold castings designated as shown in Table 1.

Committee
B 07
DocumentType
Standard
Pages
23
PublisherName
American Society for Testing and Materials
Status
Superseded
SupersededBy
Supersedes

1.1This specification2 covers aluminum-alloy permanent mold castings designated as shown in Table 1.

1.2This specification is for aluminum-alloy permanent mold castings used in general purpose applications. It may not address the mechanical properties, integrity testing, and verification required for highly loaded or safety critical applications.

1.3Alloy and temper designations are in accordance with ANSI H35.1/H35.1(M).

1.4Unless the order specifies the “M” specification designation, the material shall be furnished to the inch-pound units.

1.5For acceptance criteria for inclusion of new aluminum and aluminum alloys and their properties in this specification, see Annex A1 and Annex A2.

1.6Units—The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.7This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.8This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D 3951 : 1998 Standard Practice for Commercial Packaging
ASTM E 1251 : 1994 : R1999 Standard Test Method for Optical Emission Spectrometric Analysis of Aluminum and Aluminum Alloys by the Argon Atmosphere, Point-to-Plane, Unipolar Self-Initiating Capacitor Discharge
ASTM E 2422 : 2005 Standard Digital Reference Images for Inspection of Aluminum Castings
ASTM E 1251 : 2017 Standard Test Method for Analysis of Aluminum and Aluminum Alloys by Spark Atomic Emission Spectrometry
ASTM D 3951 : 2015 Standard Practice for Commercial Packaging
ASTM D 3951 : 2018 Standard Practice for Commercial Packaging
ASTM E 1251 : 2017 : REV A Standard Test Method for Analysis of Aluminum and Aluminum Alloys by Spark Atomic Emission Spectrometry
ASTM E 2422 : 2017 Standard Digital Reference Images for Inspection of Aluminum Castings

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.