ASTM B 124/B124M : 2018 : REV A
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Specification for Copper and Copper Alloy Forging Rod, Bar, and Shapes
Hardcopy , PDF
18-04-2019
English
01-10-2018
Important note : Users cannot be edited or removed once added to your Multi user PDF.This specification establishes the requirements for copper and copper alloy rod, bar, and shapes intended for hot forging.
| Committee |
B 05
|
| DocumentType |
Standard
|
| Pages |
8
|
| ProductNote |
This standard also refer to JIS H 1068
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1This specification establishes the requirements for copper and copper alloy rod, bar, and shapes intended for hot forging. The following coppers and copper alloys are involved:
| Copper UNS Nos. | Copper Alloy | Copper Alloy | |
| C11000 | C27450 | C49350 | CW612N |
| C14500 | C27451 | C49355 | CW617N |
| C14700 | C27453 | C49360 | |
| C28500 | C61900 | ||
| C35330 | C62300 | ||
| C36500 | C63000 | ||
| C37000 | C63200 | ||
| C37700 | C64200 | ||
| C46400 | C64210 | ||
| C46500 | C65500 | ||
| C46750 | C65680 | ||
| C48200 | C67500 | ||
| C48500 | C67600 | ||
| C48600 | C69150 | ||
| C48640 | C69240 | ||
| C49250 | C69300 | ||
| C49255 | C69410 | ||
| C49260 | C70620 | ||
| C49265 | C71520 | ||
| C49300 | C77400 | ||
| C49340 | C87700 | ||
| C49345 | C87710 | ||
Note 1:Additional information about forging practice and forgings produced from these alloys is given in Appendix X1 and in Specification B283/B283M.
1.2Units—The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory requirements prior to use.
1.4This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
| MSS SP-80:2019 | Bronze Gate, Globe, Angle and Check Valves |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.