ASTM B 152/B152M : 2019 : REDLINE
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Specification for Copper Sheet, Strip, Plate, and Rolled Bar
PDF , Hardcopy Redline , PDF Redline
12-07-2024
English
01-10-2019
Important note : Users cannot be edited or removed once added to your Multi user PDF.| Committee |
B 05
|
| DocumentType |
Redline
|
| Pages |
6
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1This specification2 establishes the requirements for copper sheet, strip, plate, and rolled bar produced from the following coppers.
| Copper | Previous | Type of Copper |
| C10100B | OFE | Oxygen-free electronic |
| C10200B | OF | Oxygen-free without residual |
| C10300 | OFXLP | Oxygen-free extra low phosphorus |
| C10400, C10500, C10700 | OFS | Oxygen-free, silver bearing |
| C10800 | OFLP | Oxygen-free low phosphorus |
| C10910 | ... | Low oxygen |
| C11000B, C | ETP, | Electrolytic tough pitch,C Tough pitchC |
| C11300, C11400, C11600B | STP | Silver bearing tough pitch |
| C12000 | DLP | Phosphorized, low residual phos- |
| C12200B | DHP | Phosphorized, high residual phos- |
| C12300 | DHPS | Phosphorized, silver bearing |
| C14200 | DPA | Phosphorus deoxidized, arsenical |
| C14420 | ... | Tin bearing tellurium copper |
| C14530 | ... | Tin tellurium bearing copper |
Note 1:Each of the coppers listed has unique properties that can make it suitable for specific applications. The purchaser should consult with the supplier to determine which copper would be best suited for the intended application.
Note 2:This specification is not intended to establish requirements for material rolled to ounce-weight thicknesses. Such material is defined in Specification B370.
Flat copper products with finished (rolled or drawn) edges (flat wire and strip) are defined in Specification B272.
1.1.1When a specific copper is not identified in the contract or purchase order, the supplier may furnish product from any of the listed coppers.
1.2Units—The values stated in either inch-pound units or SI units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other and values from the two systems shall not be combined.
1.3The following safety hazard caveat pertains only to the test method(s) described in this specification:
1.3.1This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.