ASTM B 163 : 2011 : EDT 2
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Specification for Seamless Nickel and Nickel Alloy Condenser and Heat-Exchanger Tubes
Hardcopy , PDF
18-03-2015
English
01-10-2011
Important note : Users cannot be edited or removed once added to your Multi user PDF.CONTAINED IN VOL. 02.04, 2017 Specifies seamless tubes of nickel and nickel alloys, for use in condenser and heat-exchanger service.
| Committee |
B 02
|
| DocumentType |
Standard
|
| Pages |
13
|
| ProductNote |
Reconfirmed EDT 2
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1This specification2 covers seamless tubes of nickel and nickel alloys, as shown in Table 1, for use in condenser and heat-exchanger service.
1.2This specification covers outside diameter and average wall, or outside diameter and minimum wall tube.
1.2.1The sizes covered by this specification are 3 in. (76.2 mm) and under in outside diameter with minimum wall thicknesses of 0.148 in. (3.76 mm) and under, and with average wall thicknesses of 0.165 in. (4.19 mm) and under.
1.3Tube shall be furnished in the alloys and conditions as shown in Table 2. For small diameter and light wall tube (converter sizes), see Appendix X2.
1.4The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.5The following safety hazards caveat pertains only to the test method portion, Section 12, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Material Safety Data Sheet (MSDS) for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.
| MIL-STD-129 Revision R:2014 | Military Marking for Shipment and Storage |
| ASTM E 1473 : 2016 : REDLINE | Standard Test Methods for Chemical Analysis of Nickel, Cobalt and High-Temperature Alloys |
| FED-STD-123 Revision H:2007 | MARKING FOR SHIPMENT (CIVIL AGENCIES) |
| FED-STD-102 Revision B:1963 | PRESERVATION, PACKAGING, AND PACKING LEVELS |
| ASTM E 8 : 2004 | Standard Test Methods for Tension Testing of Metallic Materials |
| FED-STD-182 Revision B:1977 | CONTINUOUS IDENTIFICATION MARKING OF NICKEL AND NICKEL BASE ALLOYS |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.