ASTM B 216 : 2016
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Specification for Tough-Pitch Fire-Refined Copper—Refinery Shapes
Hardcopy , PDF
18-06-2022
English
20-05-2016
Committee |
B 05
|
DocumentType |
Standard
|
Pages |
6
|
PublisherName |
American Society for Testing and Materials
|
Status |
Superseded
|
SupersededBy | |
Supersedes |
1.1This specification establishes the requirements for tough-pitch fire-refined copper wire bars, cakes, slabs, and billets for fabricating into wrought products and ingot and ingot bars for use in the manufacture of copper and copper alloy castings. This copper is not intended for electrical purposes.
1.2Copper under this specification corresponds to the designation “FRTP” (UNS C12500) as shown in Classification B224. This copper may also be used to produce other designations of copper where the chemical composition limits are not lower then those listed for C12500 in Table 1.
1.3Although this specification includes certain UNS designations as described in Practice E527, these designations are for cross reference only and are not specification requirements. Therefore, in case of conflict, this ASTM specification shall govern.
1.4Units—The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.5The following safety hazard caveat pertains only to the test method described in the annex of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and to determine the applicability of regulatory limitations prior to use.
ASTM B 187/B187M : 2020 | Standard Specification for Copper, Bus Bar, Rod, and Shapes and General Purpose Rod, Bar, and Shapes |
ASTM B 152/B152M : 2019 | Standard Specification for Copper Sheet, Strip, Plate, and Rolled Bar |
ASTM B 950 : 2021 : EDT 1 | Standard Guide for Editorial Procedures and Form of Product Specifications for Copper and Copper Alloys |
ASTM E 29 : 2013 : R2019 | Standard Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications |
ASTM E 29 : 2002 | Standard Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications |
ASTM E 53 : 1998 | Standard Test Method for Determination of Copper in Unalloyed Copper by Gravimetry |
ASTM E 255 : 1991 : R1997 | Standard Practice for Sampling Copper and Copper Alloys for the Determination of Chemical Composition |
ASTM E 53 : 2007 : R2013 | Standard Test Method for Determination of Copper in Unalloyed Copper by Gravimetry (Withdrawn 2022) |
ASTM E 50 : 1982 : R1986 | Standard Practices for Apparatus, Reagents, and Safety Precautions for Chemical Analysis of Metals |
ASTM E 29 : 2022 | Standard Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.