ASTM B 68M : 1999
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Specification for Seamless Copper Tube, Bright Annealed [Metric]
Hardcopy , PDF
11-11-2014
English
10-09-1999
Important note : Users cannot be edited or removed once added to your Multi user PDF.CONTAINED IN VOL. 02.01, 2009 Identifies requirements for bright annealed seamless copper tube for refrigeration, oil and gasoline lines, etc., where tube with an interior surface without dirt and scale is needed.
| Committee |
B 05
|
| DocumentType |
Standard
|
| Pages |
5
|
| ProductNote |
Reconfirmed 1999
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy |
1.1 This specification establishes the requirements for bright annealed seamless copper tube suitable for use in refrigeration, oil lines, gasoline lines, etc., where tube with an interior surface essentially free from scale and dirt is required.
1.1.1 Tubes made from any of the following Copper UNS No. designations may be supplied, unless otherwise specified in the contract or purchase order:
Copper UNS No. 2 Type of Copper C10200 Oxygen-free without residual deoxidants C10300 Oxygen-free, extra low phosphorus C10800 Oxygen-free, low phosphorus C12000 Phosphorus Deoxidized, low residual phosphorus C12200 Phosphorus Deoxidized, high residual phosphorus1.2 Values stated in SI units are the standard.
1.3 This specification is the companion to inch-pound Specification B68.
1.4 The following hazard statement pertains only to the test method described in Sections 20.5 and 21.2.6 of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
| ASTM E 8M : 2004 | Standard Test Methods for Tension Testing of Metallic Materials [Metric] (Withdrawn 2008) |
| ASTM E 527 : 2016 : REDLINE | Standard Practice for Numbering Metals and Alloys in the Unified Numbering System (UNS) |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.