ASTM B 905 : 2000 : R2005
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Test Methods for Assessing the Adhesion of Metallic and Inorganic Coatings by the Mechanized Tape Test
Hardcopy , PDF
11-11-2014
English
01-06-2005
CONTAINED IN VOL. 02.05, 2017 Specifies procedures to assess the adhesion of metallic and inorganic coatings and other thin films to nonmetallic and metallic substrates.
Committee |
B 08
|
DocumentType |
Test Method
|
Pages |
6
|
ProductNote |
Reconfirmed 2005
|
PublisherName |
American Society for Testing and Materials
|
Status |
Superseded
|
SupersededBy | |
Supersedes |
1.1 These test methods describe procedures for assessing the adhesion of metallic and inorganic coatings and other thin films to metallic and nonmetallic substrates. Assessment is made by applying pressure-sensitive tape to a coated surface and then utilizing a mechanical device to remove the tape at a regulated, uniform rate and constant angle while simultaneously recording the removal force.
1.2 Four methods are described. Methods A1 and A2 are intended primarily for use on parts. Methods B1 and B2 are intended primarily for use in laboratory evaluations. Methods B1 and B2 are not recommended for testing coatings and films on polymer substrates.
1.3 These test methods may be used to establish whether the adhesion of a coating to a substrate is within a required range (between a quantified low and a quantified high level). Determination of actual adhesive forces requires more sophisticated methods of measurement. In multilayer systems adhesion failure may occur between intermediate coating layers so that the adhesion of the total coating system to the substrate may not necessarily be determined.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
ASTM B 629 : 1977 : R2019 | Standard Practice for Preparation of Molybdenum and Molybdenum Alloys for Electroplating |
ASTM D 2370 : 2016 : REDLINE | Standard Test Method for Tensile Properties of Organic Coatings |
ASTM B 343 : 1992 : REV A : R2004 : EDT 1 | Standard Practice for Preparation of Nickel for Electroplating with Nickel |
ASTM D 1732 : 2003 | Standard Practices for Preparation of Magnesium Alloy Surfaces for Painting |
ASTM B 538 : 70(R1979) | METHOD OF TESTING FACT [FORD ANODIZED ALUMINUM CORROSION TEST] |
ASTM B 480 : 1988 | GUIDE FOR PREPARATION OF MAGNESIUM AND MAGNESIUM ALLOYS FOR ELECTROPLATING |
ASTM D 3330/D3330M : 2004 | Standard Test Method for Peel Adhesion of Pressure-Sensitive Tape |
ASTM B 320 : 1960 : R2019 | Standard Practice for Preparation of Iron Castings for Electroplating |
ASTM D 3359 : 2017 : REDLINE | Standard Test Methods for Rating Adhesion by Tape Test |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.