ASTM B 963 : 2017 : REDLINE
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Test Methods for Oil Content, Oil-Impregnation Efficiency, and Surface-Connected Porosity of Sintered Powder Metallurgy (PM) Products Using Archimedes’ Principle
28-09-2022
English
11-05-2017
Important note : Users cannot be edited or removed once added to your Multi user PDF.CONTAINED IN VOL. 02.05, 2015 Specifies three related test methods that cover the measurement of physical properties of oil-impregnated powder metallurgy products.
| Committee |
B 09
|
| DevelopmentNote |
Supersedes ASTM B 328. (06/2009)
|
| DocumentType |
Redline
|
| Pages |
6
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy |
1.1This standard describes three related test methods that cover the measurement of physical properties of oil-impregnated powder metallurgy products.
1.1.1Determination of the volume percent of oil contained in the material.
1.1.2Determination of the efficiency of the oil-impregnation process.
1.1.3Determination of the percent surface-connected porosity by oil impregnation.
1.2With the exception of the values for density and the mass used to determine density, for which the use of the gram per cubic centimetre (g/cm3) and gram (g) units is the long-standing industry practice, the values in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.4This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
| ASTM B 925 : 2015 : REDLINE | Standard Practices for Production and Preparation of Powder Metallurgy (PM) Test Specimens |
| ASTM B 438 : 2017 : REDLINE | Standard Specification for Bronze-Base Powder Metallurgy (PM) Bearings (Oil-Impregnated) |
| ASTM B 595 : 2011 : R2016 | Standard Specification for Sintered Aluminum Structural Parts |
| ASTM B 595 : 2011 | Standard Specification for Sintered Aluminum Structural Parts |
| ASTM B 783 : 2013 : REDLINE | Standard Specification for Materials for Ferrous Powder Metallurgy (PM) Structural Parts |
| ASTM B 823 : 2015 : REDLINE | Standard Specification for Materials for Copper Base Powder Metallurgy (PM) Structural Parts |
| ASTM D 1217 : 2015 : REDLINE | Standard Test Method for Density and Relative Density (Specific Gravity) of Liquids by Bingham Pycnometer |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.