• Shopping Cart
    There are no items in your cart

ASTM C 1030 : 2010 : R2018

Current

Current

The latest, up-to-date edition.

Standard Test Method for Determination of Plutonium Isotopic Composition by Gamma-Ray Spectrometry

Available format(s)

Hardcopy , PDF

Language(s)

English

Published date

01-04-2018

€56.53
Excluding VAT

Committee
C 26
DocumentType
Test Method
Pages
9
PublisherName
American Society for Testing and Materials
Status
Current
Supersedes

1.1This test method is applicable to the determination of isotopic abundances in isotopically homogeneous plutonium-bearing materials. This test method may be applicable to other plutonium-bearing materials, some of which may require modifications to the described test method.

1.2The procedure is applicable to items containing plutonium masses ranging from a few tens of milligrams up to the maximum plutonium mass allowed by criticality limits.

1.3Measurable gamma ray emissions from plutonium cover the energy range from approximately 30 keV to above 800 keV. K-X-ray emissions from plutonium and its daughters are found in the region around 100 keV. This test method has been applied to all portions of this broad spectrum of emissions.

1.4The isotopic abundance of the 242Pu isotope is not directly determined because it has no useful gamma-ray signature. Isotopic correlation techniques may be used to estimate its relative abundance Refs (1) and (2).2

1.5This test method has been demonstrated in routine use for isotopic abundances ranging from 99 to <50 %  239Pu. This test method has also been employed for isotopic abundances outside this range.

1.6The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.7This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.8This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM C 1316 : 2008 : R2017 Standard Test Method for Nondestructive Assay of Nuclear Material in Scrap and Waste by Passive-Active Neutron Counting Using <sup>252</sup>Cf Shuffler
ASTM C 1500 : 2008 : R2017 Standard Test Method for Nondestructive Assay of Plutonium by Passive Neutron Multiplicity Counting
ASTM C 1514 : 2008 : R2017 Standard Test Method for Measurement of <sup> 235</sup>U Fraction Using Enrichment Meter Principle
ASTM C 1718 : 2010 : R2019 Standard Test Method for Nondestructive Assay of Radioactive Material by Tomographic Gamma Scanning
ASTM C 1493 : 2019 Standard Test Method for Non-Destructive Assay of Nuclear Material in Waste by Passive and Active Neutron Counting Using a Differential Die-Away System
ASTM C 1133/C1133M : 2010 : R2018 Standard Test Method for Nondestructive Assay of Special Nuclear Material in Low-Density Scrap and Waste by Segmented Passive Gamma-Ray Scanning
ASTM C 1458 : 2016 Standard Test Method for Nondestructive Assay of Plutonium, Tritium and <sup >241</sup>Am by Calorimetric Assay
ASTM C 1490 : 2014 Standard Guide for the Selection, Training and Qualification of Nondestructive Assay (NDA) Personnel

ASTM C 1207 : 1997 Standard Test Method for Nondestructive Assay of Plutonium in Scrap and Waste by Passive Neutron Coincidence Counting
ASTM E 181 : 2017 Standard Test Methods for Detector Calibration and Analysis of Radionuclides
ASTM C 1458 : 2000 Standard Test Method for Nondestructive Assay of Plutonium, Tritium and <sup>241</sup>Am by Calorimetric Assay
ASTM C 1207 : 2010 : R2018 Standard Test Method for Nondestructive Assay of Plutonium in Scrap and Waste by Passive Neutron Coincidence Counting
ASTM C 1500 : 2002 Standard Test Method for Nondestructive Assay of Plutonium by Passive Neutron Multiplicity Counting
ASTM E 181 : 2023 Standard Guide for Detector Calibration and Analysis of Radionuclides in Radiation Metrology for Reactor Dosimetry
ASTM C 1316 : 1995 Standard Test Method for Nondestructive Assay of Nuclear Material in Scrap and Waste by Passive-Active Neutron Counting Using a 252 Cf Shuffler
ASTM C 1493 : 2001 Standard Test Method for Non-Destructive Assay of Nuclear Material in Waste by Passive and Active Neutron Counting Using a Differential Die-Away System

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.