ASTM C 1201/C1201M : 2015 : REDLINE
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Test Method for Structural Performance of Exterior Dimension Stone Cladding Systems by Uniform Static Air Pressure Difference
09-11-2020
English
01-05-2015
Important note : Users cannot be edited or removed once added to your Multi user PDF.CONTAINED IN VOL. 04.07, 2015 Defines the determination of the structural performance of dimension stone cladding systems under positive and negative uniform static air pressure differences, using a test chamber.
| Committee |
C 18
|
| DevelopmentNote |
Supersedes ASTM C 1201. (05/2009)
|
| DocumentType |
Redline
|
| Pages |
5
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1This test method covers the determination of the structural performance of dimension stone cladding systems under positive and negative uniform static air pressure differences, using a test chamber.
1.2The proper use of this test method requires a knowledge of the principles of pressure and deflection measurement.
1.3This test method describes the apparatus and the procedure to be used for applying either specific test loads or unknown ultimate values of uniformity distributed test loads to a specimen.
1.3.1Procedure A (see 11.2) shall be used when deflections at maximum load only are required.
1.3.2Procedure B (see 11.3) shall be used when a load-deflection curve is required.
1.4The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.5This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 7.
| CSA S304 : 2014 | DESIGN OF MASONRY STRUCTURES |
| ASTM C 1799/C1799M : 2014 | Standard Guide to Dimension Stone Test Specimen Sampling and Preparation |
| ANSI A58.1 : 1982 | DESIGN LOADS FOR BUILDINGS AND OTHER STRUCTURES, MINIMUM, |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.