• Shopping Cart
    There are no items in your cart

ASTM C 1366 : 2004

Superseded

Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View Superseded by

Standard Test Method for Tensile Strength of Monolithic Advanced Ceramics at Elevated Temperatures

Available format(s)

Hardcopy , PDF

Superseded date

11-11-2014

Language(s)

English

Published date

01-05-2004

€96.91
Excluding VAT

CONTAINED IN VOL. 15.01, 2018 Includes determination of tensile strength under uniaxial loading of monolithic advanced ceramics at elevated temperatures.

Committee
C 28
DocumentType
Test Method
Pages
27
ProductNote
Reconfirmed 2004
PublisherName
American Society for Testing and Materials
Status
Superseded
SupersededBy
Supersedes

1.1 This test method covers the determination of tensile strength under uniaxial loading of monolithic advanced ceramics at elevated temperatures. This test method addresses, but is not restricted to, various suggested test specimen geometries as listed in the appendix. In addition, test specimen fabrication methods, testing modes (force, displacement, or strain control), testing rates (force rate, stress rate, displacement rate, or strain rate), allowable bending, and data collection and reporting procedures are addressed. Tensile strength as used in this test method refers to the tensile strength obtained under uniaxial loading.

1.2 This test method applies primarily to advanced ceramics which macroscopically exhibit isotropic, homogeneous, continuous behavior. While this test method applies primarily to monolithic advanced ceramics, certain whisker, or particle-reinforced composite ceramics as well as certain discontinuous fiber-reinforced composite ceramics may also meet these macroscopic behavior assumptions. Generally, continuous fiber ceramic composites (CFCCs) do not macroscopically exhibit isotropic, homogeneous, continuous behavior and application of this test method to these materials is not recommended.

1.3 The values stated in SI units are to be regarded as the standard and are in accordance with Practice E 380.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Refer to Section 7 for specific precautions.

ASTM C 1683 : 2010 : R2019 Standard Practice for Size Scaling of Tensile Strengths Using Weibull Statistics for Advanced Ceramics

ASTM E 380 : 1993 Standard Practice for Use of the Internation System of Units (SI) (the Modernized Metric System) (Withdrawn 1997)
ASTM E 83 : 2016 : REDLINE Standard Practice for Verification and Classification of Extensometer Systems
IEEE/ASTM SI_10-2010 American National Standard for Metric Practice
ASTM C 1322 : 2015 : REDLINE PRACTICE FOR FRACTOGRAPHY AND CHARACTERIZATION OF FRACTURE ORIGINS IN ADVANCED CERAMICS
ASTM E 337 : 2015 : REDLINE Standard Test Method for Measuring Humidity with a Psychrometer (the Measurement of Wet- and Dry-Bulb Temperatures)
ASTM E 220 : 2013 : REDLINE Standard Test Method for Calibration of Thermocouples By Comparison Techniques
ASTM D 3379 : 1975 TEST METHOD FOR TENSILE STRENGTH AND YOUNG'S MODULUS FOR HIGH-MODULUS SINGLE-FILAMENT MATERIALS

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.