ASTM C 443 : 2019 : REV A
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Specification for Joints for Concrete Pipe and Manholes, Using Rubber Gaskets
Hardcopy , PDF
05-05-2020
English
01-07-2019
Important note : Users cannot be edited or removed once added to your Multi user PDF.CONTAINED IN VOL. 04.05, 2017 Specifies flexible watertight joints for concrete pipe and precast manhole sections, using rubber gaskets for sealing the joints, where infiltration or exfiltration is a factor in the design.
| Committee |
C 13
|
| DocumentType |
Standard
|
| Pages |
5
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy |
1.1This specification covers flexible leak-resistant joints for concrete pipe and precast manhole sections, using rubber gaskets for sealing the joints, where infiltration or exfiltration is a factor in the design. The specification covers the design of joints and the requirements for rubber gaskets to be used therewith, for pipe conforming in all other respects to Specification C14, Specification C76, or Specification C507 and precast manhole section conforming in all other respects to Specification C478, provided that if there is conflict in permissible variations in dimensions the requirements of this specification for joints shall govern.
1.2A complete metric companion to Specification C443 has been developed—C443M; therefore, no metric equivalents are presented in this specification.
Note 1:This specification covers the design and performance of the rubber gasket joint only. Joints covered by this specification are adequate for hydrostatic pressures up to 13 psi (30 ft), when tested in accordance with Section 9. Infiltration or exfiltration quantities for an installed pipeline are dependent upon many factors other than the joints, and allowable quantities must be covered by other specifications and suitable testing of the installed pipeline and system.
1.3This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
| ASTM C 1619 : 2019 | Standard Specification for Elastomeric Seals for Joining Concrete Structures |
| ASTM C 1619 : 2011 | Standard Specification for Elastomeric Seals for Joining Concrete Structures |
| ASTM C 1619 : 2005 | Standard Specification for Elastomeric Seals for Joining Concrete Structures |
| ASTM C 1619 : 2011 : R2017 | Standard Specification for Elastomeric Seals for Joining Concrete Structures |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.