ASTM D 1179 : 2004
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Test Methods for Fluoride Ion in Water
Hardcopy , PDF
11-11-2014
English
01-07-2004
Committee |
D 19
|
DocumentType |
Test Method
|
Pages |
6
|
PublisherName |
American Society for Testing and Materials
|
Status |
Superseded
|
SupersededBy | |
Supersedes |
1.1 These test methods cover the determination of fluoride ion in water. The following two test methods are given:
Sections | |
Test Method A-Distillation | 7 to 13 |
Test Method B-Ion Selective Electrode | 14 to 22 |
1.2 Test Method A covers the accurate measurement of total fluoride in water through isolation of the fluoride by distillation and subsequent measurement in the distillate by use of the ion selective electrode (ISE) method. The procedure covers the range from 0.1 to 2.6 mg/L of fluoride.
1.3 Test Method B covers the accurate measurement of simple fluoride ion in water by means of an ion selective electrode. With this test method, distillation is eliminated because the electrode is not affected by the interferences common to colorimetric procedures. Concentrations of fluoride from 0.1 to 1000 mg/L may be measured.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For a specific precautionary statement, see 12.1.2.
1.5 Former Test Method A, SPADNS Photometric Procedure, was discontinued. Refer to Appendix X1 for historical information.
ASTM D 5091 : 1995 : R2014 | Standard Guide for Water Analysis for Electrodialysis/Electrodialysis Reversal Applications (Withdrawn 2023) |
ASTM D 4195 : 2008 : R2014 | Standard Guide for Water Analysis for Reverse Osmosis and Nanofiltration Application (Withdrawn 2023) |
ASTM F 2168 : 2013 | Standard Specification for Packing Material, Graphitic, Corrugated Ribbon or Textured Tape, and Die-Formed Ring |
ASTM F 2191/F2191M : 2013 | Standard Specification for Packing Material, Graphitic or Carbon Braided Yarn |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.