ASTM D 229 : 2013
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Test Methods for Rigid Sheet and Plate Materials Used for Electrical Insulation
Hardcopy , PDF
13-03-2019
English
14-11-2013
Important note : Users cannot be edited or removed once added to your Multi user PDF.| Committee |
D 09
|
| DocumentType |
Test Method
|
| Pages |
18
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1These test methods cover procedures for testing rigid electrical insulation normally manufactured in flat sheet or plate form. They are generally used as terminal boards, spacers, voltage barriers, and circuit boards.
1.2Use Test Methods D619 (withdrawn) or Specification D710 for tests applying to vulcanized fibre.
1.3Some of the test methods contained in this standard are similar to those contained in IEC 60893-2, which applies to rigid industrial laminated sheets based on thermosetting resins for electrical purposes.
1.4The test methods appear in the following sections:
| Test | Sections | ASTM |
| Acetone extractable matter | 83 to 84 | D494 |
| Arc resistance | 47 | D495 |
| Ash | 56 to 60 | ... |
| Bonding strength | 49 to 54 | ... |
| Burning rate and flame resistance | 61 to 75 | ... |
| Compressive strength | 25 | D695 |
| Conditioning | 4 | D6054 |
| Dissipation factor | 34 to 40 | D669 |
| Dielectric strength | 28 to 33 | D149 |
| Expansion (linear thermal) | 76 | D696 |
| Flexural properties | 12 to 24 | D790 |
| Hardness (Rockwell) | 55 | D785 |
| Insulation resistance and resistivity | 41 to 46 | D257 |
| Permittivity | 34 to 40 | D150 |
| Resistance to impact | 26 | D256 |
| Tensile properties | 7 to 11 | D638 |
| Thickness | 5 to 6 | D374 |
| Tracking resistance | 48 | D2132 |
| Warp or twist | 77 to 82 | ... |
| Water absorption | 27 | D570 |
1.5The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.6This is a fire-test-response standard. See Sections 61 through 75, which are the procedures for burning rate and flame resistance.
1.7This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in 31.1 and 1.8.
1.8This standard measures and describes the response of materials, products, or assemblies to heat and flame under controlled conditions, but does not by itself incorporate all factors required for fire hazard or fire risk assessment of the materials, products, or assemblies under actual fire conditions.
1.9Fire testing is inherently hazardous. Adequate safeguards for personnel and property shall be employed in conducting these tests.
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.