ASTM D 2694 : 2005 : R2019

1.1This specification covers diethylene glycol for use in the preparation of surface coatings.

1.2The following applies to all specified limits in this standard: for purposes of determining conformance with this standard, an observed value or a calculated value shall be rounded off “to the nearest unit” in the last right-hand digit used in expressing the specification limit of Practice E29.

1.3The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.4For specific hazard information and guidance, consult the supplier's Material Safety Data Sheet.

1.5This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.