ASTM D 2718 : 2000 : R2011 : EDT 1
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Test Methods for Structural Panels in Planar Shear (Rolling Shear)
02-03-2024
01-11-2011
CONTAINED IN VOL. 04.10, 2017 Specifies the shear properties of structural panels associated with shear distortion of the planes parallel to the edge planes of the panels.
| Committee |
D 07
|
| DocumentType |
Test Method
|
| ProductNote |
Reconfirmed EDT 1
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1These test methods determine the shear properties of structural panels associated with shear distortion of the planes parallel to the edge planes of the panels. Both shear strength and modulus of rigidity may be determined. Primarily, the tests measure the planar shear (rolling shear) strength developed in the plane of the panel.
1.2Structural panels in use include plywood, waferboard, oriented strand board, and composites of veneer and of wood-based layers.
1.3Two test methods are included:
1.3.1Test Method A—Planar shear loaded by plates.
1.3.2Test Method B—Planar shear induced by five-point bending.
1.3.3The choice of method will be dictated by the purpose of the test and equipment available.
1.3.4Test Method A, Planar Shear Loaded by Plates—This test method uses a rectangular panel section adhered between steel plates with protruding knife edges to create load at the panel faces. This test method has been used to develop shear properties of plywood and oriented strand board for the purpose of confirming design values. This test method does not produce pure shear, but the specimen length is prescribed so that the secondary stresses have a minimum effect. The method determines shear strength and modulus of rigidity.
1.3.5Test Method B, Planar Shear Induced by Five-Point Bending—Planar shear stress is induced on the panel while loaded in bending using two continuous spans. This test method determines planar shear strength consistent with panel applications under transverse loading. This test method is able to determine shear strength at any moisture condition.
1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.5This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
| ASTM D 5456 : 2019 | Standard Specification for Evaluation of Structural Composite Lumber Products |
| ASTM D 5457 : 2019 : REV B | Standard Specification for Computing Reference Resistance of Wood-Based Materials and Structural Connections for Load and Resistance Factor Design |
| ASTM D 7033 : 2014 | Standard Practice for Establishing Design Capacities for Oriented Strand Board (OSB) Wood-Based Structural-Use Panels |
| ASTM D 3044 : 2016 | Standard Test Method for Shear Modulus of Wood-Based Structural Panels |
| ASTM D 4442 : 2016 : REDLINE | Standard Test Methods for Direct Moisture Content Measurement of Wood and Wood-Based Materials |
| ASTM D 2395 : 2017 : REDLINE | Standard Test Methods for Density and Specific Gravity (Relative Density) of Wood and Wood-Based Materials |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.