ASTM D 2783 : 2021
Current
The latest, up-to-date edition.
Standard Test Method for Measurement of Extreme-Pressure Properties of Lubricating Fluids (Four-Ball Method)
Hardcopy , PDF
English
21-01-2022
Important note : Users cannot be edited or removed once added to your Multi user PDF.| Committee |
D 02
|
| DocumentType |
Test Method
|
| Pages |
9
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Current
|
| Supersedes |
1.1This test method covers the determination of the load-carrying properties of lubricating fluids. The following two determinations are made:
1.1.1Load-wear index (formerly Mean-Hertz load).
1.1.2Weld point by means of the four-ball extreme-pressure (EP) tester.
1.2For the determination of the load-carrying properties of lubricating greases, see Test Method D2596.
1.3The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard.
1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
| ASTM D 3233 : 2019 | Standard Test Methods for Measurement of Extreme Pressure Properties of Fluid Lubricants (Falex Pin and Vee Block Methods) |
| ASTM D 8324 : 2021 | Standard Guide for Selection of Environmentally Acceptable Lubricants for the U.S. Environmental Protection Agency (EPA) Vessel General Permit |
| ASTM D 7044 : 2015 | Standard Specification for Biodegradable Fire Resistant Hydraulic Fluids (Withdrawn 2024) |
| ASTM G 40 : 2021 : REV A | Standard Terminology Relating to Wear and Erosion |
| ASTM G 40 : 2022 | Standard Terminology Relating to Wear and Erosion |
| ASTM G 40 : 2022 : REV A | Standard Terminology Relating to Wear and Erosion |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.