ASTM D 2967 : 2007 : R2017
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Test Method for Corner Coverage of Powder Coatings
Hardcopy , PDF
16-09-2024
English
01-06-2017
CONTAINED IN VOL. 06.02, 2017 Defines the determination of the ratio of corner thickness to face thickness of powder coatings applied to a specific face thickness by dipping preheated square bars into aerated powder and curing the coating using predetermined conditions.
Committee |
D 01
|
DocumentType |
Test Method
|
Pages |
3
|
ProductNote |
Reconfirmed 2017
|
PublisherName |
American Society for Testing and Materials
|
Status |
Superseded
|
SupersededBy | |
Supersedes |
1.1This test method covers the determination of the ratio of corner thickness (see 3.1.3) to face thickness (see 3.1.4) of powder coatings applied to a specific face thickness by dipping preheated square bars into aerated powder and curing the coating using predetermined conditions.
Note 1:The property of corner coverage has also been referred to as “edge coverage,” though the latter is not recommended. There are widespread misunderstandings and expectations relative to the term “edge coverage.” This test is performed on a steel bar having square corners and the results do not necessarily relate to edges that are sharper, that is, burrs. A coating that has measurable corner coverage may still not protect sharper edges from corrosion or provide the electrical insulation needed in some applications.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.4This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
ASTM D 4242 : 2007 : R2017 | Standard Test Method for Inclined Plate Flow for Thermosetting Coating Powders |
ASTM D 3451 : 2006 : R2017 | Standard Guide for Testing Coating Powders and Powder Coatings |
ASTM A 775/A775M : 2019 | Standard Specification for Epoxy-Coated Steel Reinforcing Bars |
ASTM D 3963/D3963M : 2021 | Standard Specification for Fabrication and Jobsite Handling of Epoxy-Coated Steel Reinforcing Bars |
ASTM D 1711 : 2024 | Standard Terminology Relating to Electrical Insulation |
ASTM A 775/A775M : 2022 | Standard Specification for Epoxy-Coated Steel Reinforcing Bars |
ASTM D 374/D374M : 2016 | Standard Test Methods for Thickness of Solid Electrical Insulation |
ASTM D 374/D374M : 2023 | Standard Test Methods for Thickness of Solid Electrical Insulation |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.