ASTM D 3154 : 2000
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Test Method for Average Velocity in a Duct (Pitot Tube Method)
Hardcopy , PDF
11-11-2014
English
10-09-2000
Important note : Users cannot be edited or removed once added to your Multi user PDF.| Committee |
D 22
|
| DocumentType |
Test Method
|
| Pages |
11
|
| ProductNote |
Reconfirmed 2000
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy |
1.1 This test method describes measurement of the average velocity of a gas stream for the purpose of determining gas flow in a stack, duct, or flue. Although technically complex, it is generally considered the most accurate and often the only practical test method for taking velocity measurements.
1.2 This test method is suitable for measuring gas velocities above 3 m/s (10 ft/s).
1.3 This test method provides procedures for determining stack gas composition and moisture content.
1.4 The values stated in SI units are to be regarded as standard. The inch-pound units given in parentheses are for information only.
1.5 This test method is applicable to conditions where steady-state flow occurs, and for constant fluid conditions. If these conditions are not meant, other methods must be used.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
| ASTM D 6331 : 2016 | Standard Test Method for Determination of Mass Concentration of Particulate Matter from Stationary Sources at Low Concentrations (Manual Gravimetric Method) |
| ASTM D 5835 : 1995 : R2013 | Standard Practice for Sampling Stationary Source Emissions for the Automated Determination of Gas Concentrations |
| ASTM F 1977 : 2004 : R2017 | Standard Test Method for Determining Initial, Fractional, Filtration Efficiency of a Vacuum Cleaner System |
| ASTM D 3685/D3685M : 2013 | Standard Test Methods for Sampling and Determination of Particulate Matter in Stack Gases |
| ASTM D 6784 : 2016 | Standard Test Method for Elemental, Oxidized, Particle-Bound and Total Mercury in Flue Gas Generated from Coal-Fired Stationary Sources (Ontario Hydro Method) |
| ASTM D 6060 : 2017 | Standard Test Method for Sampling of Process Vents with a Portable Gas Chromatograph |
| ASTM D 6831 : 2011 : R2018 | Standard Test Method for Sampling and Determining Particulate Matter in Stack Gases Using an In-Stack, Inertial Microbalance |
| ASTM D 7295 : 2018 | Standard Practice for Sampling Combustion Effluents and Other Stationary Sources for the Subsequent Determination of Hydrogen Cyanide |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.