ASTM D 3657 : 1988 : R1998 : EDT 1
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
Standard Specification for Zipper Dimensions
11-11-2014
01-01-1998
| Committee |
D 13
|
| DocumentType |
Standard
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
1.1 This specification establishes standard dimensions for zippers of all materials for specified size designation; for equivalency, in inch-pound and metric units, of zipper length and length tolerances, of tape width and width tolerances, and of tape end lengths.
Note 1-For other methods of evaluating zippers refer to the following ASTM methods: D2051, D2052, D2053, D2054, D2057, D2058, D2059, D2061, and D2062.1.2 The values stated in SI units are to be regarded as the standard.
1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
| ASTM D 2060 : 2014 : EDT 1 | Standard Test Methods for Measuring Zipper Dimensions |
| ASTM D 2050 : 2019 | Standard Terminology Relating to Subassemblies Used in the Manufacture of Textiles |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.