ASTM D 3795 : 2000 : REV A : R2006
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Test Method for Thermal Flow, Cure, and Behavior Properties of Pourable Thermosetting Materials by Torque Rheometer
Hardcopy , PDF
11-11-2014
English
15-03-2006
Important note : Users cannot be edited or removed once added to your Multi user PDF.CONTAINED IN VOL. 08.02, 2014 Describes the apparatus, and a specific test method, including the evaluation of results required for the determination of the thermal flow and cure behavior properties of pourable thermosetting materials.
| Committee |
D 20
|
| DocumentType |
Test Method
|
| Pages |
5
|
| ProductNote |
Reconfirmed 2006
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1 This test method covers the apparatus, and a specific test method, including the evaluation of results required for the determination of the thermal flow and cure behavior properties of pourable thermosetting materials.
1.2 This test method can be used:
1.2.1 As a control for the development and production of pourable thermosetting materials and to measure the different properties (for example, melting behavior, cure behavior, etc.) as well as the influence of various additives and fillers in any given formulations, and
1.2.2 Verify the uniformity of different production batches of the same formulation.
1.3 The values are stated in SI units.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautions are given in Section 7.Note 1
There is no similar or equivalent ISO standard.
| ASTM D 1896/D1896M : 2010 : R2017 | Standard Practice for Transfer Molding Test Specimens of Thermosetting Compounds |
| ASTM D 704 : 1999 : R2012 | Standard Specification for Melamine-Formaldehyde Molding Compounds |
| ASTM D 792 : 2013 : REDLINE | Standard Test Methods for Density and Specific Gravity (Relative Density) of Plastics by Displacement |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.