Skip to content
Please enter a keyword to search

  • ASTM D 4552/D4552M : 2010 : R2016 : EDT 1

    View superseded by
    Superseded A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
    View superseded by

    Standard Practice for Classifying Hot-Mix Recycling Agents

    Available format(s):  Hardcopy, PDF

    Superseded date:  14-08-2020

    Language(s):  English

    Published date:  01-12-2016

    Publisher:  American Society for Testing and Materials

    Add To Cart

    Abstract - (Show below) - (Hide below)

    CONTAINED IN VOL. 04.03, 2016 Defines a standardized method whereby petroleum product additives to be used in hot recycling of asphalt concrete can be identified.

    Scope - (Show below) - (Hide below)

    1.1This practice covers a standardized method whereby petroleum product additives to be used in hot recycling of asphalt concrete can be identified. The products are classified by viscosity in mm2/s measured at 60 °C [140 °F]. This practice does not apply to emulsified materials.

    1.2The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.

    1.3This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    General Product Information - (Show below) - (Hide below)

    Committee D 04
    Development Note Supersedes ASTM D 4552. (08/2010)
    Document Type Standard Practice
    Product Note Reconfirmed EDT 1
    Publisher American Society for Testing and Materials
    Status Superseded
    Superseded By
    Supersedes

    Standards Referencing This Book - (Show below) - (Hide below)

    ASTM D 1298 : 2012 : REV A Standard Test Method for Density, Relative Density (Specific Gravity), or API Gravity of Crude Petroleum and Liquid Petroleum Products by Hydrometer Method
    ASTM D 2872 : 2019 Standard Test Method for Effect of Heat and Air on a Moving Film of Asphalt (Rolling Thin-Film Oven Test)
    ASTM D 2007 : 2003 : R2008 Standard Test Method for Characteristic Groups in Rubber Extender and Processing Oils and Other Petroleum-Derived Oils by the Clay-Gel Absorption Chromatographic Method
    ASTM D 3381 : 2005 Standard Specification for Viscosity-Graded Asphalt Cement for Use in Pavement Construction
    ASTM D 1298 : 2012 : REV B Standard Test Method for Density, Relative Density, or API Gravity of Crude Petroleum and Liquid Petroleum Products by Hydrometer Method
    ASTM D 2007 : 2003 : EDT 1 Standard Test Method for Characteristic Groups in Rubber Extender and Processing Oils and Other Petroleum-Derived Oils by the Clay-Gel Absorption Chromatographic Method
    ASTM D 2007 : 2019 Standard Test Method for Characteristic Groups in Rubber Extender and Processing Oils and Other Petroleum-Derived Oils by the Clay-Gel Absorption Chromatographic Method
    ASTM D 1298 : 1999 : R2005 Standard Test Method for Density, Relative Density (Specific Gravity), or API Gravity of Crude Petroleum and Liquid Petroleum Products by Hydrometer Method
    ASTM D 1298 : 2012 : REV B : R2017 Standard Test Method for Density, Relative Density, or API Gravity of Crude Petroleum and Liquid Petroleum Products by Hydrometer Method
    ASTM D 1298 : 2012 Standard Test Method for Density, Relative Density (Specific Gravity), or API Gravity of Crude Petroleum and Liquid Petroleum Products by Hydrometer Method
    ASTM D 2170 : 2001 : REV A : R2006 Standard Test Method for Kinematic Viscosity of Asphalts (Bitumens)
    ASTM D 2007 : 2011 Standard Test Method for Characteristic Groups in Rubber Extender and Processing Oils and Other Petroleum-Derived Oils by the Clay-Gel Absorption Chromatographic Method
    ASTM D 2170 : 1995 Standard Test Method for Kinematic Viscosity of Asphalts (Bitumens)
    ASTM D 1298 : 1999 : EDT 2 Standard Test Method for Density, Relative Density (Specific Gravity), or API Gravity of Crude Petroleum and Liquid Petroleum Products by Hydrometer Method
    ASTM D 2007 : 2002 Standard Test Method for Characteristic Groups in Rubber Extender and Processing Oils and Other Petroleum-Derived Oils by the Clay—Gel Absorption Chromatographic Method
    ASTM D 1298 : 1999 Standard Test Method for Density, Relative Density (Specific Gravity), or API Gravity of Crude Petroleum and Liquid Petroleum Products by Hydrometer Method
    ASTM D 2007 : 2001 : REV A Standard Test Method for Characteristic Groups in Rubber Extender and Processing Oils and Other Petroleum-Derived Oils by the Clay—Gel Absorption Chromatographic Method
    ASTM D 1754 : 1997 Standard Test Method for Effect of Heat and Air on Asphaltic Materials (Thin-Film Oven Test)
    ASTM D 2170 : 2007 Standard Test Method for Kinematic Viscosity of Asphalts (Bitumens)
    ASTM D 2872 : 2012 : EDT 1 Standard Test Method for Effect of Heat and Air on a Moving Film of Asphalt (Rolling Thin-Film Oven Test)
    ASTM D 2170 : 2001 : REV A Standard Test Method for Kinematic Viscosity of Asphalts (Bitumens)
    ASTM D 2007 : 2011 : R2016 Standard Test Method for Characteristic Groups in Rubber Extender and Processing Oils and Other Petroleum-Derived Oils by the Clay-Gel Absorption Chromatographic Method
    ASTM D 1298 : 1999 : EDT 1 Standard Test Method for Density, Relative Density (Specific Gravity), or API Gravity of Crude Petroleum and Liquid Petroleum Products by Hydrometer Method
    ASTM D 2872 : 2012 Standard Test Method for Effect of Heat and Air on a Moving Film of Asphalt (Rolling Thin-Film Oven Test)
    ASTM D 3381 : 2009 Standard Specification for Viscosity-Graded Asphalt Cement for Use in Pavement Construction
    ASTM D 2171 : 2007 : EDT 1 Standard Test Method for Viscosity of Asphalts by Vacuum Capillary Viscometer
    ASTM D 2171 : 1994 Standard Test Method for Viscosity of Asphalts by Vacuum Capillary Viscometer
    ASTM D 2007 : 2003 Standard Test Method for Characteristic Groups in Rubber Extender and Processing Oils and Other Petroleum-Derived Oils by the Clay-Gel Absorption Chromatographic Method
    ASTM D 2872 : 1997 Standard Test Method for Effect of Heat and Air on a Moving Film of Asphalt (Rolling Thin-Film Oven Test)
    ASTM D 2171 : 2001 Standard Test Method for Viscosity of Asphalts by Vacuum Capillary Viscometer
    ASTM D 2872 : 2004 Standard Test Method for Effect of Heat and Air on a Moving Film of Asphalt (Rolling Thin-Film Oven Test)
    ASTM D 1298 : 1985 : R1990 : EDT 1 Standard Practice for Density, Relative Density (Specific Gravity), or API Gravity of Crude Petroleum and Liquid Petroleum Products by Hydrometer Method
    ASTM D 2007 : 2001 Standard Test Method for Characteristic Groups in Rubber Extender and Processing Oils and Other Petroleum-Derived Oils by the Clay—Gel Absorption Chromatographic Method
    ASTM D 2171 : 2007 Standard Test Method for Viscosity of Asphalts by Vacuum Capillary Viscometer
    ASTM D 3381 : 1992 : R1999 Standard Specification for Viscosity-Graded Asphalt Cement for Use in Pavement Construction
    ASTM D 2170 : 2001 Standard Test Method for Kinematic Viscosity of Asphalts (Bitumens)
    ASTM D 2007 : 1998 Standard Test Method for Characteristic Groups in Rubber Extender and Processing Oils and Other Petroleum-Derived Oils by the Clay—Gel Absorption Chromatographic Method
    View more information

    • Access your standards online with a subscription

      Features

      • Simple online access to standards, technical information and regulations
      • Critical updates of standards and customisable alerts and notifications
      • Multi - user online standards collection: secure, flexibile and cost effective