ASTM D 4643 : 2000
NA
Status of Standard is Unknown
Standard Test Method for Determination of Water (Moisture) Content of Soil by the Microwave Oven Method
Hardcopy , PDF
English
10-02-2000
Important note : Users cannot be edited or removed once added to your Multi user PDF.| Committee |
D 18
|
| DocumentType |
Test Method
|
| Pages |
5
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
NA
|
| SupersededBy |
1.1 This test method outlines procedures for determining the water (moisture) content of soils by incrementally drying soil in a microwave oven.
1.2 This test method is not intended as a replacement for Test Method D2216; but, rather as a supplement when more rapid results are required or desired to expedite other phases of testing. Test Method
1.3 When questions of accuracy between this test method and Test Method
1.4 This test method is applicable for most soil types. For some soils, such as those containing significant amounts of halloysite, mica, montmorillonite, gypsum or other hydrated materials, highly organic soils, or soils in which the pore water contains dissolved solids (such as salt in the case of marine deposits), this test method may not yield reliable water content values.
1.5 The values stated in SI units are to be regarded as the standard.
1.6 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. See Section 7.
Note 1-Notwithstanding statements of precision and bias contained in this standard, the precision of this test method is dependent on the competence of the personnel performing it and the suitability of the equipment and facilities used. Agencies that meet the criteria of Practice| ASTM D 5993 : 2018 | Standard Test Method for Measuring Mass per Unit Area of Geosynthetic Clay Liners |
| ASTM F 1815 : 2011 : R2018 | Standard Test Methods for Saturated Hydraulic Conductivity, Water Retention, Porosity, and Bulk Density of Athletic Field Rootzones |
| ASTM D 2216 : 2019 | Standard Test Methods for Laboratory Determination of Water (Moisture) Content of Soil and Rock by Mass |
| ASTM D 3839 : 2014 | Standard Guide for Underground Installation of “Fiberglass” (Glass-Fiber Reinforced Thermosetting-Resin) Pipe |
| ASTM D 6758 : 2018 | Standard Test Method for Measuring Stiffness and Apparent Modulus of Soil and Soil-Aggregate In-Place by Electro-Mechanical Method |
| ASTM D 7876 : 2013 : R2018 | Standard Practice for Practice for Sample Decomposition Using Microwave Heating (With or Without Prior Ashing) for Atomic Spectroscopic Elemental Determination in Petroleum Products and Lubricants |
| ASTM D 5890 : 2019 | Standard Test Method for Swell Index of Clay Mineral Component of Geosynthetic Clay Liners |
| ASTM D 7698 : 2011 : REV A | Standard Test Method for In-Place Estimation of Density and Water Content of Soil and Aggregate by Correlation with Complex Impedance Method |
| ASTM D 5874 : 2016 | Standard Test Methods for Determination of the Impact Value (IV) of a Soil |
| ASTM E 3163 : 2018 | Standard Guide for Selection and Application of Analytical Methods and Procedures Used during Sediment Corrective Action |
| ASTM D 2937 : 2017 : EDT 2 | Standard Test Method for Density of Soil in Place by the Drive-Cylinder Method |
| ASTM D 2167 : 2015 | Standard Test Method for Density and Unit Weight of Soil in Place by the Rubber Balloon Method (Withdrawn 2024) |
| ASTM D 8167/D8167M : 2018 : REV A | Standard Test Method for In-Place Bulk Density of Soil and Soil-Aggregate by a Low-Activity Nuclear Method (Shallow Depth) |
| ASTM D 5126 : 2016 : EDT 1 | Standard Guide for Comparison of Field Methods for Determining Hydraulic Conductivity in Vadose Zone |
| ASTM D 6938 : 2017 : REV A | Standard Test Methods for In-Place Density and Water Content of Soil and Soil-Aggregate by Nuclear Methods (Shallow Depth) |
| ASTM D 7830/D7830M : 2014 | Standard Test Method for In-Place Density (Unit Weight) and Water Content of Soil Using an Electromagnetic Soil Density Gauge |
| ASTM D 1556/D1556M : 2015 : EDT 1 | Standard Test Method for Density and Unit Weight of Soil in Place by Sand-Cone Method (Withdrawn 2024) |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.