ASTM D 5133 : 2015 : REDLINE
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Test Method for Low Temperature, Low Shear Rate, Viscosity/Temperature Dependence of Lubricating Oils Using a Temperature-Scanning Technique
24-04-2020
English
01-06-2015
Important note : Users cannot be edited or removed once added to your Multi user PDF.CONTAINED IN VOL. 05.02, 2015 Defines the measurement of the apparent viscosity of engine oil at low temperatures.
| Committee |
D 02
|
| DocumentType |
Redline
|
| Pages |
16
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy |
1.1This test method covers the measurement of the apparent viscosity of engine oil at low temperatures.
1.2A shear rate of approximately 0.2 s-1 is produced at shear stresses below 100 Pa. Apparent viscosity is measured continuously as the sample is cooled at a rate of 1 °C/h over the range −5 °C to −40 °C, or to the temperature at which the viscosity exceeds 40 000 mPa·s (cP).
1.3The measurements resulting from this test method are viscosity, the maximum rate of viscosity increase (Gelation Index), and the temperature at which the Gelation Index occurs.
1.4Applicability to petroleum products other than engine oils has not been determined in preparing this test method.
1.5The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.6This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
| API 1509 : 2002 | ENGINE OIL LICENSING AND CERTIFICATION SYSTEM |
| ASTM D 8185 : 2018 | Standard Guide for In-Service Lubricant Viscosity Measurement |
| ASTM D 4485 : 2017-03 | SPECIFICATION FOR PERFORMANCE OF ACTIVE API SERVICE CATEGORY ENGINE OILS |
| SAE J183_201708 | Engine Oil Performance and Engine Service Classification (Other than \"Energy Conserving\") |
| BIS IS 13656 : 2014 | INTERNAL COMBUSTION ENGINE CRANKCASE OILS FOR AUTOMOTIVE APPLICATION (DIESEL AND GASOLINE) - SPECIFICATION |
| SAE J300_201501 | Engine Oil Viscosity Classification |
| SAE J357_201601 | Physical and Chemical Properties of Engine Oils |
| ASTM D 341 : 2017 : REDLINE | Standard Practice for Viscosity-Temperature Charts for Liquid Petroleum Products |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.