Skip to content
Please enter a keyword to search

  • ASTM D 5337 : 2011 : R2016

    View superseded by
    Superseded A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
    View superseded by

    Standard Practice for Flow Rate Adjustment of Personal Sampling Pumps

    Available format(s):  Hardcopy, PDF

    Superseded date:  09-06-2023

    Language(s):  English

    Published date:  11-11-2016

    Publisher:  American Society for Testing and Materials

    Add To Cart

    Abstract - (Show below) - (Hide below)

    CONTAINED IN VOL. 11.03, 2015 Defines the calibration of sampling pumps commonly used for monitoring personal airborne exposures in the work-place.

    Scope - (Show below) - (Hide below)

    1.1This practice describes the calibration of sampling pumps commonly used for monitoring personal airborne exposures in the work-place.

    1.2This practice includes procedures for describing primary and secondary calibration techniques.

    1.3The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

    1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    General Product Information - (Show below) - (Hide below)

    Committee D 22
    Document Type Standard Practice
    Product Note Reconfirmed 2016
    Publisher American Society for Testing and Materials
    Status Superseded
    Superseded By
    Supersedes

    Standards Referenced By This Book - (Show below) - (Hide below)

    ASTM E 2144 : 2021 Standard Practice for Personal Sampling and Analysis of Endotoxin in Metalworking Fluid Aerosols in Workplace Atmospheres
    ASTM D 6494 : 2022 Standard Test Method for Determination of Asphalt Fume Particulate Matter in Workplace Atmospheres as Benzene Soluble Fraction
    ASTM D 4490 : 2023 Standard Practice for the Use of Detector Tubes in the Measurement of Toxic Gases and Vapors
    ASTM D 8345 : 2021 Standard Test Method for Determination of an Emission Parameter for Phthalate Esters and Other Non-Phthalate Plasticizers from Planar Polyvinyl Chloride Indoor Materials for Use in Mass Transfer Modeling Calculations
    ASTM D 7773 : 2019 Standard Test Method for Determination of Volatile Inorganic Acids (HCl, HBr, and HNO3) Using Filter Sampling and Suppressed Ion Chromatography
    ASTM D 5075 : 2001 : R2022 Standard Test Method for Nicotine and 3-Ethenylpyridine in Indoor Air
    ASTM D 6562 : 2020 Standard Test Method for Determination of Gaseous Hexamethylene Diisocyanate (HDI) in Air with 9-(N-methylaminomethyl) Anthracene Method (MAMA) in the Workplace
    ASTM D 7201 : 2006 : R2020 Standard Practice for Sampling and Counting Airborne Fibers, Including Asbestos Fibers, in the Workplace, by Phase Contrast Microscopy (with an Option of Transmission Electron Microscopy)
    ASTM D 4532 : 2022 Standard Test Method for Respirable Dust in Workplace Atmospheres Using Cyclone Samplers
    ASTM D 7948 : 2020 Standard Test Method for Measurement of Respirable Crystalline Silica in Workplace Air by Infrared Spectrometry
    ASTM D 7035 : 2021 Standard Test Method for Determination of Metals and Metalloids in Airborne Particulate Matter by Inductively Coupled Plasma Atomic Emission Spectrometry (ICP-AES)
    ASTM D 6561 : 2020 Standard Test Method for Determination of Aerosol Monomeric and Oligomeric Hexamethylene Diisocyanate (HDl) in Air with (Methoxy-2–phenyl-1) Piperazine (MOPIP) in the Workplace
    ASTM D 7144 : 2021 Standard Practice for Collection of Surface Dust by Micro-vacuum Sampling for Subsequent Determination of Metals and Metalloids
    ASTM D 3686 : 2020 Standard Practice for Sampling Atmospheres to Collect Organic Compound Vapors (Activated Charcoal Tube Adsorption Method)
    ASTM D 6785 : 2020 Standard Test Method for Determination of Lead in Workplace Air Using Flame or Graphite Furnace Atomic Absorption Spectrometry
    ASTM D 4600 : 2022 Standard Test Method for Determination of Benzene-Soluble Particulate Matter in Workplace Atmospheres
    ASTM D 5932 : 2020 Standard Test Method for Determination of 2,4-Toluene Diisocyanate (2,4-TDI) and 2,6-Toluene Diisocyanate (2,6-TDI) in Air (with 9-(N-Methylaminomethyl) Anthracene Method) (MAMA) in the Workplace
    ASTM D 7202 : 2022 Standard Test Method for Determination of Beryllium in the Workplace by Extraction and Optical Fluorescence Detection
    ASTM D 5836 : 2020 Standard Test Method for Determination of 2,4-Toluene Diisocyanate (2,4-TDI) and 2,6-Toluene Diisocyanate (2,6-TDI) in Workplace Atmospheres (1-2 PP Method)
    ASTM D 8142 : 2017 : EDT 1 Standard Test Method for Determining Chemical Emissions from Spray Polyurethane Foam (SPF) Insulation using Micro-Scale Environmental Test Chambers
    ASTM D 8142 : 2017 Standard Test Method for Determining Chemical Emissions from Spray Polyurethane Foam (SPF) Insulation using Micro-Scale Environmental Test Chambers
    ASTM D 6562 : 2012 Standard Test Method for Determination of Gaseous Hexamethylene Diisocyanate (HDI) in Air with 9-(N-methylaminomethyl) Anthracene Method (MAMA) in the Workplace
    ASTM D 8208 : 2019 Standard Practice for Collection of Non-Fibrous Nanoparticles Using a Nanoparticle Respiratory Deposition (NRD) Sampler
    ASTM D 5955 : 2002 : R2017 : EDT 1 Standard Test Methods for Estimating Contribution of Environmental Tobacco Smoke to Respirable Suspended Particles Based on UVPM and FPM (Withdrawn 2022)
    ASTM E 2144 : 2011 : R2016 Standard Practice for Personal Sampling and Analysis of Endotoxin in Metalworking Fluid Aerosols in Workplace Atmospheres
    ASTM D 7143 : 2017 Standard Practice for Emission Cells for the Determination of Volatile Organic Emissions from Indoor Materials/Products
    ASTM D 7049 : 2017 Standard Test Method for Metalworking Fluid Aerosol in Workplace Atmospheres
    ASTM D 4532 : 2015 Standard Test Method for Respirable Dust in Workplace Atmospheres Using Cyclone Samplers
    ASTM D 5075 : 2001 : R2017 : EDT 1 Standard Test Method for Nicotine and 3-Ethenylpyridine in Indoor Air
    ASTM D 6561 : 2006 : R2016 Standard Test Method for Determination of Aerosol Monomeric and Oligomeric Hexamethylene Diisocyanate (HDl) in Air with (Methoxy-2–phenyl-1) Piperazine (MOPIP) in the Workplace
    ASTM D 4185 : 2017 Standard Test Method for Measurement of Metals in Workplace Atmospheres by Flame Atomic Absorption Spectrophotometry
    ASTM D 7200 : 2012 Standard Practice for Sampling and Counting Airborne Fibers, Including Asbestos Fibers, in Mines and Quarries, by Phase Contrast Microscopy and Transmission Electron Microscopy (Withdrawn 2021)
    ASTM D 7339 : 2018 Standard Test Method for Determination of Volatile Organic Compounds Emitted from Carpet using a Specific Sorbent Tube and Thermal Desorption / Gas Chromatography
    ASTM D 6271 : 2010 : R2016 Standard Test Method for Estimating Contribution of Environmental Tobacco Smoke to Respirable Suspended Particles Based on Solanesol (Withdrawn 2022)
    ASTM D 3686 : 2013 Standard Practice for Sampling Atmospheres to Collect Organic Compound Vapors (Activated Charcoal Tube Adsorption Method)
    ASTM D 7706 : 2017 Standard Practice for Rapid Screening of VOC Emissions from Products Using Micro-Scale Chambers
    ASTM D 7201 : 2006 : R2011 Standard Practice for Sampling and Counting Airborne Fibers, Including Asbestos Fibers, in the Workplace, by Phase Contrast Microscopy (with an Option of Transmission Electron Microscopy)
    ASTM D 7202 : 2015 Standard Test Method for Determination of Beryllium in the Workplace by Extraction and Optical Fluorescence Detection
    ASTM D 7773 : 2012 Standard Test Method for Determination of Volatile Inorganic Acids (HCl, HBr, and HNO3 ) Using Filter Sampling and Suppressed Ion Chromatography
    ASTM D 4765 : 2013 : R2018 Standard Test Method for Measurement of Fluorides in Workplace Atmospheres by Ion-Selective Electrodes
    ASTM D 7295 : 2018 Standard Practice for Sampling Combustion Effluents and Other Stationary Sources for the Subsequent Determination of Hydrogen Cyanide

    Standards Referencing This Book - (Show below) - (Hide below)

    ASTM D 1356 : 2015 Standard Terminology Relating to Sampling and Analysis of Atmospheres
    ASTM D 1356 : 2017 Standard Terminology Relating to Sampling and Analysis of Atmospheres
    ASTM D 1356 : 2015 : REV B Standard Terminology Relating to Sampling and Analysis of Atmospheres
    ASTM D 1356 : 2014 : REV A Standard Terminology Relating to Sampling and Analysis of Atmospheres
    ASTM D 1356 : 2015 : REV A Standard Terminology Relating to Sampling and Analysis of Atmospheres
    ASTM D 1356 : 2005 : R2010 Standard Terminology Relating to Sampling and Analysis of Atmospheres
    ASTM D 1356 : 2020 Standard Terminology Relating to Sampling and Analysis of Atmospheres
    ASTM D 1356 : 2000 : REV A Standard Terminology Relating to Sampling and Analysis of Atmospheres
    ASTM D 1356 : 2014 : REV B Standard Terminology Relating to Sampling and Analysis of Atmospheres
    ASTM D 1356 : 2014 Standard Terminology Relating to Sampling and Analysis of Atmospheres
    ASTM D 1356 : 2005 Standard Terminology Relating to Sampling and Analysis of Atmospheres
    View more information

    • Access your standards online with a subscription

      Features

      • Simple online access to standards, technical information and regulations
      • Critical updates of standards and customisable alerts and notifications
      • Multi - user online standards collection: secure, flexibile and cost effective