1.1This specification covers circular contact-molded fiberglass reinforced-thermosetting-resin flanges for use in pipe systems and tank nozzles. Included are requirements for materials, workmanship, performance, and dimensions.
1.2Flanges (see Fig. 1) may be produced as integral flanges, Type A, or flange-on-pipe, Type B.
1.3This specification is based on flange performance and does not cover design.
1.4These flanges are designed for use with pipe and tanks that are manufactured to Specifications D2996, D2997, D3262, D3299, D3517, D3754, and D4097.
1.5Selection of gaskets is not covered in this specification, refer to the manufacturer's recommendation.
1.6The values stated in inch-pound units are to be regarded as the standard. The SI units given in parentheses are for information only.
1.7The following precautionary caveat pertains only to the test methods portion, Section 9, of this specification: This standard does not purport to address the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Note 1:There is no known ISO equivalent to this standard.