ASTM D 5835 : 1995 : R2007
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Practice for Sampling Stationary Source Emissions for the Automated Determination of Gas Concentrations
Hardcopy , PDF
11-11-2014
English
01-04-2007
CONTAINED IN VOL. 11.03, 2015 Defines procedures and equipment that will permit, within certain limits, representative sampling for the automated determination of gas concentrations of effluent gas streams.
Committee |
D 22
|
DocumentType |
Standard Practice
|
Pages |
8
|
ProductNote |
Reconfirmed 2007
|
PublisherName |
American Society for Testing and Materials
|
Status |
Superseded
|
SupersededBy | |
Supersedes |
1.1 This practice covers procedures and equipment that will permit, within certain limits, representative sampling for the automated determination of gas concentrations of effluent gas streams. The application is limited to the determination of oxygen (O
1.2 Velocity measurements are required to determine the mass flow rates of gases. This is not included in this practice.
1.3 There are some combustion processes and situations that may limit the applicability of this practice. Where such conditions exist, caution and competent technical judgment are required, especially when dealing with any of the following:
1.3.1 Corrosive or highly reactive components,
1.3.2 High vacuum, high pressure, or high temperature gas streams,
1.3.3 Wet flue gases,
1.3.4 Fluctuations in velocity, temperature, or concentration due to uncontrollable variation in the process,
1.3.5 Gas stratification due to the non-mixing of gas streams,
1.3.6 Measurements made using environmental control devices, and
1.3.7 Low levels of gas concentrations.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
ASTM D 1608 : 2016 : REDLINE | Standard Test Method for Oxides of Nitrogen in Gaseous Combustion Products (Phenol-Disulfonic Acid Procedures) |
ASTM D 3154 : 2014 : REDLINE | Standard Test Method for Average Velocity in a Duct (Pitot Tube Method) |
CFR 40(PT60) : JUL 2016 | PROTECTION OF ENVIRONMENT - ENVIRONMENTAL PROTECTION AGENCY |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.