• There are no items in your cart

ASTM D 5965 : 2002

Superseded

Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View Superseded by

Standard Test Methods for Specific Gravity of Coating Powders

Available format(s)

Hardcopy , PDF

Superseded date

11-11-2014

Language(s)

English

Published date

10-01-2002

€59.22
Excluding VAT

CONTAINED IN VOL. 06.02, 2017 Defines three procedures for determining the specific gravity (see definition) of coating powders, as follows: Test Method A - For Testing Coating Powders, Excluding Metallics. Test Method B - For Tests Requiring Greater Precision than Test Method A, Including Metallics, Using Helium Pycnometry. Test Method C - For Theoretical Calculation Based on Raw Material Specific Gravities.

Committee
D 01
DocumentType
Test Method
Pages
4
ProductNote
Reconfirmed 2002
PublisherName
American Society for Testing and Materials
Status
Superseded
SupersededBy
Supersedes

1.1 These test methods cover three procedures for determining the specific gravity (see definition) of coating powders, as follows:

TEST METHOD A—For Testing Coating Powders, Excluding Metallics
TEST METHOD B—For Tests Requiring Greater Precision than Test Method A, Including Metallics, Using Helium Pycnometry
TEST METHOD C—For Theoretical Calculation Based on Raw Material Specific Gravities

1.2 Test Method A can be used as a less expensive method with reduced accuracy for determining the specific gravity of coating powders, excluding metallics.

1.3 The ideal gas law forms the basis for all calculations used in the Test Method B determination of density of coating powders.

1.4 Test Method B includes procedures that provided acceptable results for samples analyzed during round robin testing.

1.5 Test Method B uses SI units as standard. State all numerical values in terms of SI units unless specific instrumentation software reports surface area using alternate units. Many instruments report density as g/cm3, instead of using SI units (kg/m3).

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM D 4242 : 2007 : R2017 Standard Test Method for Inclined Plate Flow for Thermosetting Coating Powders
ASTM B 1000 : 2015 Standard Practices for Casting Preparation and Test Procedure of Porcelain Enamel-lined Pipe, Fittings, and Valves for Use in the Municipal Wastewater, Sewage, and Water Treatment Industry
ASTM D 3451 : 2006 : R2017 Standard Guide for Testing Coating Powders and Powder Coatings

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.