ASTM D 619 : 2014
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Test Methods for Vulcanized Fibre Used for Electrical Insulation
Hardcopy , PDF
15-02-2021
English
04-12-2014
Important note : Users cannot be edited or removed once added to your Multi user PDF.CONTAINED IN VOL. 10.01, 2017 Defines the procedures for testing vulcanized fibre sheets, tubes, and rods of such grades as can be used for electrical insulation.
| Committee |
D 09
|
| DocumentType |
Test Method
|
| Pages |
8
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1These test methods cover the procedures for testing vulcanized fibre sheets, tubes, and rods of such grades as can be used for electrical insulation.
1.2The procedures appear in the following sections:
| Procedure | Section |
| Arc resistance | 23 |
| Ash | 6 |
| Bond strength (ply adhesion) | 16 |
| Bursting strength | 14 |
| Compressive strength | 12, 25, 30 |
| Conditioning | 4 |
| Density | 17, 26, 32 |
| Dielectric strength | 18, 27 |
| Dimensional measurements | 28, 33 |
| Flammability | 22 |
| Flexural strength | 13, 31 |
| Silica | 7 |
| Tearing strength | 11 |
| Tensile strength | 10, 24, 29 |
| Thickness (sheets) | 20 |
| Resistance to impact | 15 |
| Rockwell hardness | 19 |
| Volatile matter | 8 |
| Water absorption | 5 |
| Zinc chloride | 9 |
1.3The values stated in inch-pound units are to be regarded as the standard. The SI values given in parentheses are for information only.
1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazard statements are given in 7.3, 22.1, 22.2.
Note 1:The test methods described herein are similar technically to those described in IEC Publication 60667-2. Not all of the tests in this document are included in IEC 60667-2, and the procedures in the two publications are not completely identical; but it is expected that comparable results will be obtained from most of the procedures. Conduct comparative tests if necessary before directly comparing results of tests using the different procedures.
| ASTM D 710 : 2013 : REDLINE | Standard Specification for Vulcanized Fibre Sheets, Rods, and Tubes Used for Electrical Insulation |
| ASTM D 710 : 2019 | Standard Specification for Vulcanized Fibre Sheets, Rolls, Rods, and Tubes Used for Electrical Insulation |
| ASTM D 229 : 2019 : EDT 1 | Standard Test Methods for Rigid Sheet and Plate Materials Used for Electrical Insulation |
| MIL-F-10336 Revision E:1977 | FIBER SHEET, VULCANIZED |
| IEEE 1310-2012 REDLINE | IEEE Recommended Practice for Thermal Cycle Testing of Form-Wound Stator Bars and Coils for Large Rotating Machines |
| ASTM D 495 : 2014 | Standard Test Method for High-Voltage, Low-Current, Dry Arc Resistance of Solid Electrical Insulation |
| ASTM D 710 : 2013 : REDLINE | Standard Specification for Vulcanized Fibre Sheets, Rods, and Tubes Used for Electrical Insulation |
| ASTM D 689 : 2017 | Standard Test Method for Internal Tearing Resistance of Paper |
| ASTM D 668 : 2012 : REDLINE | Standard Test Methods of Measuring Dimensions of Rigid Rods and Tubes Used for Electrical Insulation |
| ASTM D 1711 : 2002 | Standard Terminology Relating to Electrical Insulation |
| ASTM D 349 : 2013 : REDLINE | Standard Test Methods for Laminated Round Rods Used for Electrical Insulation |
| ASTM D 952 : 2015 : REDLINE | Standard Test Method for Bond or Cohesive Strength of Sheet Plastics and Electrical Insulating Materials |
| ASTM D 1711 : 2015 : REDLINE | Standard Terminology Relating to Electrical Insulation |
| ASTM D 1711 : 2011 | Standard Terminology Relating to Electrical Insulation |
| ASTM D 792 : 2013 : REDLINE | Standard Test Methods for Density and Specific Gravity (Relative Density) of Plastics by Displacement |
| ASTM D 1711 : 2011 : REV A | Standard Terminology Relating to Electrical Insulation |
| ASTM D 6054 : 1997 | Standard Practice for Conditioning Electrical Insulating Materials for Testing |
| ASTM D 1711 : 2013 | Standard Terminology Relating to Electrical Insulation |
| ASTM D 202 : 2017 : REDLINE | Standard Test Methods for Sampling and Testing Untreated Paper Used for Electrical Insulation |
| ASTM D 828 : 2016 | Standard Test Method for Tensile Properties of Paper and Paperboard Using Constant-Rate-of-Elongation Apparatus |
| ASTM D 1711 : 1999 | Standard Terminology Relating to Electrical Insulation |
| ASTM D 1711 : 2014 : REV A | Standard Terminology Relating to Electrical Insulation |
| ASTM D 1711 : 2015 | Standard Terminology Relating to Electrical Insulation |
| ASTM D 1711 : 2014 | Standard Terminology Relating to Electrical Insulation |
| ASTM D 348 : 2013 : REDLINE | Standard Test Methods for Rigid Tubes Used for Electrical Insulation |
| ASTM D 1711 : 2020 | Standard Terminology Relating to Electrical Insulation |
| ASTM D 1711 : 2008 | Standard Terminology Relating to Electrical Insulation |
| ASTM D 695 : 2015 : REDLINE | Standard Test Method for Compressive Properties of Rigid Plastics |
| ASTM D 570 : 1998 : R2018 | Standard Test Method for Water Absorption of Plastics |
| ASTM D 374 : 1999 | Standard Test Methods for Thickness of Solid Electrical Insulation |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.