• Shopping Cart
    There are no items in your cart

ASTM D 6194 : 2023

Current

Current

The latest, up-to-date edition.

Standard Test Method for Glow-Wire Ignition of Materials

Available format(s)

Hardcopy , PDF

Language(s)

English

Published date

10-02-2023

€56.53
Excluding VAT

Committee
D 09
DocumentType
Test Method
Pages
5
PublisherName
American Society for Testing and Materials
Status
Current
Supersedes

1.1This test method covers the minimum temperature required to ignite insulating materials using a glowing heat source. In a preliminary fashion, this test method differentiates between the susceptibilities of different materials with respect to their resistance to ignition due to an electrically-heated source.

1.2This test method applies to molded or sheet materials available in thicknesses ranging from 0.25 mm to 6.4 mm.

1.3This test method is not valid for determining the ignition behavior of complete electrotechnical equipment, since the design of the electrotechnical product influences the heat transfer between adjacent parts.

1.4This test method measures and describes the response or materials, products, or assemblies to heat and flame under controlled conditions, but does not by itself incorporate all factors required for fire hazard or fire risk assessment of the materials, products, or assemblies under actual fire conditions.

1.5The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. (See IEEE/ASTM SI-10 for further details.)For specific precautionary statements, see Section 9.

1.6This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific precautionary statements, see Section 9.

1.7Fire testing is inherently hazardous. Adequate safeguards for personnel and property shall be employed in conducting these tests.

Note 1:Although this test method and IEC 60695-2-12 differ in approach and in detail, data obtained to determine the glow-wire flammability index (GWFI) using either test method are technically similar. Although this test method and IEC 60695-2-13 differ in approach and in detail, data obtained to determine the glow-wire ignition temperature (GWIT) using either test method are technically similar.

1.8This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D 3874 : 2020 Standard Test Method for Ignition of Materials by Hot Wire Sources
ASTM E 3020 : 2022 Standard Practice for Ignition Sources

ASTM E 230/E230M : 2017 Standard Specification for Temperature-Electromotive Force (emf) Tables for Standardized Thermocouples
ASTM E 230/E230M : 2023 Standard Specification for Temperature-Electromotive Force (emf) Tables for Standardized Thermocouples
ASTM E 176 : 2021 : REV A : EDT 1 Standard Terminology of Fire Standards
ASTM D 1711 : 2024 : REV A Standard Terminology Relating to Electrical Insulation
ASTM E 176 : 2024 Standard Terminology of Fire Standards
ASTM E 230/E230M : 2023 : REV A Standard Specification for Temperature-Electromotive Force (emf) Tables for Standardized Thermocouples
ASTM D 1711 : 2024 Standard Terminology Relating to Electrical Insulation
ASTM D 1711 : 2022 Standard Terminology Relating to Electrical Insulation

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.