ASTM D 6320/D6320M : 2010 : R2014 : REDLINE
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
Standard Test Methods for Single Filament Hose Reinforcing Wire Made from Steel (Withdrawn 2023)
English
19-06-2014
19-06-2014
| Committee |
D 13
|
| DocumentType |
Redline
|
| Pages |
9
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
1.1These test methods cover testing of single filament steel wires that are used to reinforce hose products. By agreement, these test methods may be applied to similar filaments used for reinforcing other rubber products.
1.2These test methods describe test procedures only and do not establish specifications or tolerances.
1.3These test methods cover the determinations of the mechanical properties listed below:
| Property | Section | |
| Breaking force (strength) | 7 – 13 | |
| Yield strength | 7 – 13 | |
| Elongation | 7 – 13 | |
| Knot strength | 14 – 20 | |
| Torsion resistance | 21 – 27 | |
| Reverse bend | 28 – 34 | |
| Wrap | 35 – 41 | |
| Diameter | 42 – 48 |
1.4The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.5This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Access your standards online with a subscription
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.
Important note : Users cannot be edited or removed once added to your Multi user PDF.