ASTM D 6360 : 2007
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Practice for Enclosed Carbon-Arc Exposures of Plastics
Hardcopy , PDF
11-11-2014
English
01-03-2007
Important note : Users cannot be edited or removed once added to your Multi user PDF.| Committee |
D 20
|
| DocumentType |
Standard Practice
|
| Pages |
4
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1 This practice covers specific procedures and test conditions that are applicable for exposure of plastics in enclosed carbon-arc devices conducted in accordance with Practices G 151 and G 153. This practice also covers the preparation of test specimens, the test conditions suited for plastics, and the evaluation of test results.
1.2 This practice does not cover filtered open-flame carbon-arc exposures of plastics, which are covered in Practice D 1499. Practice D 5031 describes enclosed carbon-arc exposures of paints and related coatings.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Note 1There is no known ISO equivalent to this practice.
| ASTM D 1047 : 2016 | Standard Specification for Poly(Vinyl Chloride) Jacket for Wire and Cable |
| ASTM D 5870 : 2016 | Standard Practice for Calculating Property Retention Index of Plastics |
| ASTM D 1499 : 2013 | Standard Practice for Filtered Open-Flame Carbon-Arc Exposures of Plastics |
| ASTM D 4000 : 2016 | Standard Classification System for Specifying Plastic Materials |
| ASTM G 178 : 2016 | Standard Practice for Determining the Activation Spectrum of a Material (Wavelength Sensitivity to an Exposure Source) Using the Sharp Cut-On Filter or Spectrographic Technique |
| ASTM D 1248 : 2016 | Standard Specification for Polyethylene Plastics Extrusion Materials for Wire and Cable |
| ASTM D 4976 : 2012 : REV A | Standard Specification for Polyethylene Plastics Molding and Extrusion Materials |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.