ASTM D 6513 : 2014 : REDLINE
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Practice for Calculating the Superimposed Load on Wood-frame Walls for Standard Fire-Resistance Tests
17-08-2021
English
01-10-2014
Important note : Users cannot be edited or removed once added to your Multi user PDF.CONTAINED IN VOL. 04.10, 2015 Describes procedures for calculating the superimposed axial load required to be applied to load-bearing wood-frame walls throughout standard fire-endurance and fire and hose-stream tests.
| Committee |
D 07
|
| DocumentType |
Redline
|
| Pages |
6
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy |
1.1This practice covers procedures for calculating the superimposed axial load required to be applied to load-bearing wood-frame walls throughout standard fire-resistance and fire and hose-stream tests.
1.2The calculations determine the maximum load allowed by design for wood-frame wall assemblies under nationally recognized structural design criteria.
1.3This practice is only applicable to those wood-frame assemblies for which the nationally recognized structural design criteria is the National Design Specification for Wood Construction (NDS).2
1.4The system of units to be used is that of the nationally recognized structural design criteria. For the NDS, the units are inch-pound.
1.5The text of this standard references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard.
1.6This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
| ASTM D 7374 : 2008 | Standard Practice for Evaluating Elevated Temperature Performance of Adhesives Used in End-Jointed Lumber |
| ASTM D 7746 : 2011 : R2016 | Standard Practice for Calculating the Superimposed Load on Wood-frame Floor-Ceiling Assemblies for Standard Fire-Resistance Tests |
| ASTM D 7374 : 2008 : R2015 | Standard Practice for Evaluating Elevated Temperature Performance of Adhesives Used in End-Jointed Lumber |
| ASTM D 7470 : 2008 | Standard Practice for Evaluating Elevated Temperature Performance of End-Jointed Lumber Studs |
| ASTM E 119 : 2018-04 | TEST METHODS FOR FIRE TESTS OF BUILDING CONSTRUCTION AND MATERIALS |
| ASTM D 7746 : 2011 | Standard Practice for Calculating the Superimposed Load on Wood-frame Floor-Ceiling Assemblies for Standard Fire-Resistance Tests |
| ASTM D 7470 : 2008 : R2015 | Standard Practice for Evaluating Elevated Temperature Performance of End-Jointed Lumber Studs |
| ASTM D 9 : 2012 : REDLINE | Standard Terminology Relating to Wood and Wood-Based Products |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.