ASTM D 6767 : 2020
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Test Method for Pore Size Characteristics of Geotextiles by Capillary Flow Test
Hardcopy , PDF
15-12-2020
English
28-01-2020
Important note : Users cannot be edited or removed once added to your Multi user PDF.| Committee |
D 35
|
| DocumentType |
Test Method
|
| Pages |
6
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1This test method covers the determination of the pore size distribution of geotextile filters with pore sizes ranging from 1 to 1000 μm.
Note 1:The accuracy of this procedure has been verified up to a maximum pore size of 500 μm. Above this value, accuracy has been found to be equipment dependent and should be verified by the user through checks on materials with known opening sizes.
1.2The test method measures the entire pore size distribution in terms of a surface analysis of specified pore sizes in a geotextile, defined in terms of the limiting diameters.
1.3The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
| ASTM D 7178 : 2016 : EDT 1 | Standard Practice for Determining the Number of Constrictions “<emph type="bdit" >m</emph>” of Non-Woven Geotextiles as a Complementary Filtration Property |
| ASTM D 4354 : 2012 | Standard Practice for Sampling of Geosynthetics and Rolled Erosion Control Products(RECPs) for Testing |
| ASTM D 1129 : 2013 | Standard Terminology Relating to Water |
| ASTM D 1129 : 2013 : R2020 | Standard Terminology Relating to Water |
| ASTM D 4354 : 2012 : R2020 | Standard Practice for Sampling of Geosynthetics and Rolled Erosion Control Products (RECPs) for Testing |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.