ASTM D 6881/D6881M : 2003 : R2013

1.1This classification covers containers used to hold plastic resins with bulk density (Test Methods D1895) of 27 to 39 lb/ft³ (0.432 to 0.625 g/cm³).

1.2This classification does not apply to any plastic resins with bulk density below 27 lb/ft³ (0.432 g/cm³) or above 39lb/ft³ (0.625 g/cm³).

1.3This classification does not apply to bulk boxes containing hazardous materials.

1.4This classification does not address box/pallet unitization requirements.

1.5This classification does not address requirements of plastic bag liners normally placed inside the corrugated bulk box before filling with plastic resin.

1.6This classification does not address tamping, shaking, or other compression methods of the resin filled bulk box to condense entrained air and increase headspace in the bulk box.

1.7This classification does not address blocking and bracing or other shipping requirements normally associated with bulk box unit deliveries.

1.8This classification does not address filled bulk box/pallet unit stack height.

1.9This classification does not address international shipping regulations of bulk box/pallet units.

1.10This classification does not address pallet opening sizes for pallet trucks.

1.11The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.12This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use.

1.13This classification offers an organized collection of information or a series of options and does not recommend a specific course of action. This document cannot replace education or experience and should be used in conjunction with professional judgement. Not all aspects of this classification may be applicable in all circumstances. This ASTM standard is not intended to represent or replace the standard of care by which the adequacy of a given professional service must be judged, nor should this document be applied without consideration of a project's many unique aspects. The word “standard” in the title of this document means only that the document has been approved through the ASTM consensus process.