ASTM D 7011 : 2024

1.1This test method covers the determination of thiophene in refined benzene using gas chromatography and sulfur selective detection.

1.2This test method is applicable to the determination of thiophene at levels of 0.02 mg to 2.18 mg thiophene per kg in benzene (mg/kg) on the AED, 0.03 mg/kg to 1.87 mg/kg on the PFPD, and 0.03 mg/kg to 2.11 mg/kg on the SCD. The range of the test method may be extended by modifying the sample injection volume, split ratios, calibration range, or sample dilution with thiophene-free solvent.

1.3The following applies for the purposes of determining the conformance of the test results using this method to applicable specifications, results shall be rounded off in accordance with the rounding-off method of Practice E29.

1.4The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.5This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 8.

1.6This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.