ASTM D 7049 : 2017 : REDLINE
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Test Method for Metalworking Fluid Aerosol in Workplace Atmospheres
22-03-2024
English
03-11-2023
Important note : Users cannot be edited or removed once added to your Multi user PDF.CONTAINED IN VOL. 11.07, 2017 Includes a procedure for the determination of both total collected particulate matter and extractable mass metal removal fluid aerosol concentrations in the range of 0.05 to 5 mg/m[3] in workplace atmospheres.
| Committee |
E 34
|
| DocumentType |
Redline
|
| Pages |
6
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy |
1.1This test method covers a procedure for the determination of both total collected particulate matter and extractable mass metalworking fluid aerosol concentrations in the range of 0.07 to 5 mg/m3 in workplace atmospheres.
1.2This test method describes a standardized means of collecting worker exposure information that can be compared to existing exposure databases, using a test method that is also more specific to metal removal fluids.
1.3The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
| ASTM E 2148 : 2016 : REDLINE | Standard Guide for Using Documents Related to Metalworking or Metal Removal Fluid Health and Safety |
| ASTM E 1497 : 2017 : REDLINE | Standard Practice for Selection and Safe Use of Water-Miscible and Straight Oil Metal Removal Fluids |
| ASTM E 2889 : 2012 : R2017 | Standard Practice for Control of Respiratory Hazards in the Metal Removal Fluid Environment |
| ASHRAE HDBK REFRIGERATION : 2014 | ASHRAE HANDBOOK - REFRIGERATION |
| ASTM E 2889 : 2012 | Standard Practice for Control of Respiratory Hazards in the Metal Removal Fluid Environment |
| ASTM D 4840 : 1999 | Standard Guide for Sampling Chain-of-Custody Procedures |
| ASTM D 4532 : 2015 : REDLINE | Standard Test Method for Respirable Dust in Workplace Atmospheres Using Cyclone Samplers |
| CFR 29(PT1910.1000 TO END) : 0 | LABOR - OCCUPATIONAL SAFETY AND HEALTH ADMINISTRATION, DEPARTMENT OF LABOR |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.