ASTM D 705 : 1999
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Specification for Urea-Formaldehyde Molding Compounds
Hardcopy , PDF
11-11-2014
English
10-11-1999
Important note : Users cannot be edited or removed once added to your Multi user PDF.CONTAINED IN VOL. 08.01, 2015 Applies to compression molding thermosetting, urea-formaldehyde molding compounds.
| Committee |
D 20
|
| DocumentType |
Standard
|
| Pages |
2
|
| ProductNote |
Reconfirmed 1999
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy |
1.1 This specification covers compression molding thermosetting compounds consisting of a urea-formaldehyde resin binder intimately combined in the uncured or partially cured condition with fillers, pigments, and other chemical agents.
1.2 The values stated in SI units are to be regarded as the standard. The values stated in parentheses are for information only.
Note 1-The properties included in this specification are those required to identify the types of molding compounds covered. There may be other requirements necessary to identify particular characteristics. Transfer or injection molding will usually result in different physical and electrical characteristics than compression molding.1.3 The following safety hazards caveat pertains only to the test method portion, Section 7, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Note 2-ISO 2112-1977(E) is similar but not equivalent to this specification. Product classification and characterization are not the same.| ASTM D 495 : 2014 | Standard Test Method for High-Voltage, Low-Current, Dry Arc Resistance of Solid Electrical Insulation |
| ASTM D 618 : 2013 : REDLINE | Standard Practice for Conditioning Plastics for Testing |
| ISO 2112:1990 | Plastics Aminoplastic moulding materials Specification |
| ASTM D 792 : 2013 : REDLINE | Standard Test Methods for Density and Specific Gravity (Relative Density) of Plastics by Displacement |
| ASTM D 790 : 2017 : REDLINE | Standard Test Methods for Flexural Properties of Unreinforced and Reinforced Plastics and Electrical Insulating Materials |
| ASTM D 570 : 1998 : R2018 | Standard Test Method for Water Absorption of Plastics |
| ASTM D 956 : 1987 | Practice for Compression Molding Specimens of Amino Molding Compounds (Withdrawn 1992) |
| ASTM D 3892 : 2015 : REDLINE | PRACTICE FOR PACKAGING/PACKING OF PLASTICS |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.