ASTM D 7110 : 2015

1.1This test method covers how to measure the apparent viscosity of used and soot-containing engine oils at low temperatures.

1.2A shear rate of approximately 0.2  s^-1 is produced at shear stresses below 200 Pa. Apparent viscosity is measured continuously as the sample is cooled at a rate of 3 °C per hour over the range of −5 °C to −40 °C.

1.3The measurements resulting from this test method are viscosity, the maximum rate of viscosity increase (Gelation Index) and the temperature at which the Gelation Index occurs.

1.4Applicability to petroleum products other than engine oils has not been determined in preparing this test method.

1.5The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.6This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.