ASTM D 7238 : 2006

CONTAINED IN VOL. 04.09, 2017 Establishes the specific procedures and test conditions that are applicable for exposure of unreinforced polyolefin geomembranes to fluorescent UV radiation and condensation.

1.1 This standard covers the specific procedures and test conditions that are applicable for exposure of unreinforced polyolefin geomembranes to fluorescent UV radiation and condensation.

Polyolefin geomembranes include high density polyethylene (HDPE), linear low density polyethylene (LLDPE), flexible polyproplyene (fPP), etc.

1.2 Test specimens are exposed to fluorescent UVA 340 lamps under controlled environmental conditions. UVA 340 lamps are standard for this method.

Other types of fluorescent UV lamps, such as UVB-313, can also be used based upon discussion between involved parties. However, if the test is ran with another type of fluorescent UV lamps, such as UVB-313, this should be considered as a deviation from the standard and clearly stated in the test report. UVB-313 and UVA-340 fluorescent lamps generate different amount of radiant power in different wavelength ranges; thus, the photochemical effects caused by these different lamps may vary.

1.3 This method covers the conditions under which the exposure is to be performed and the test methods for evaluating the effects of fluorescent UV, heat and moisture in the form of condensation on geomembranes. General guidance is given in Practices G 151 and G 154.

1.4 The values listed in SI units are to be regarded as the standard.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.