ASTM D 7560 : 2022

1.1Hydraulic erosion control product (HECP) fibers are manufactured and processed to specific length and width dimensions to facilitate the hydraulic application and to prevent clogging of the pump, recirculation pipes, nozzles, and tips. This test method is used to determine the length of the fibers on a percentage basis in an HECP.

1.2This test method can be used to evaluate an HECP during and after manufacturing. The results can be used for comparative evaluations of the manufacturing process.

1.3Units—The values stated in SI units are to be regarded as the standard. No other units of measurement are included in this standard. Sieve designations are shown in both the standard and alternative designations.

1.4All observed and calculated values shall conform to the guidelines for significant digits and rounding established in Practice D6026.

1.5This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.