ASTM D 968 : 2025

1.1These test methods cover the determination of the resistance of organic coatings to abrasion produced by abrasive falling onto coatings applied to a plane rigid surface, such as a metal or glass panel.

1.2Two test methods based on different abrasives are covered as follows:

1.3These methods should be restricted to testing in only one laboratory when numerical values are used because of the poor reproducibility of the methods (see 14.1.1.2 and 14.2.1.2). Interlaboratory agreement is improved significantly when ranking is used in place of numerical values.

1.4The values stated in SI units are to be regarded as the standard. The values given in parentheses after SI units are for information only and are not considered standard.

1.5This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.